Philips MCP9350i Service Manual page 41

12.4. ODD (Optical Disk Drive)
12.4.1. ODD Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the main bezel. See paragraph 12.2.1.
3. Remove the HDD subassembly. See paragraph 12.3.1.
4. Disconnect all cables (1) from the ODD. See Figure 12.4-1.
5. Remove the 2 mounting screws (2) from the ODD. See Figure 12.4-2
6. Remove the ODD from the chassis by sliding it out towards the front.
12.4.2. ODD Re-Assembly
To re-assemble the ODD, do all processes described in paragraph 12.4.1 in reverse order.
Note: The torque setting required for the ODD mounting screws (2) is 4kg-cm
Note: Before re-assembly make sure that the jumper (3) at the rear of the ODD is set to the Master position. See Figure 12.4-3
1
Figure 12.4-1
3
Figure 12.4-3
Hardware Repair
2
MCP9350i 12.
2
Figure 12.4-2
EN 41