Visonic NEXT PG2 Installation Instructions

Visonic NEXT PG2 Installation Instructions

Powerg, wireless, pir /pet tolerant motion detector
Hide thumbs Also See for NEXT PG2:

Advertisement

Quick Links

NEXT PG2 / / / /
NEXT PG2
NEXT PG2
NEXT PG2
NEXT
NEXT
NEXT K9
NEXT
K9
K9
K9- - - - 85
PowerG, Wireless, PIR /Pet Tolerant Motion Detector

1. INTRODUCTION

1. INTRODUCTION
1. INTRODUCTION
1. INTRODUCTION
The Next PG2 and Next K9-85 PG2 are 2-way, microprocessor-controlled, wireless digital PIR detectors.
The detectors features are as follows:
• For use with all PowerMaster® control panels (version 10 and higher).
• Combined Fresnel and cylindrical optics, up to 15 meters (49 ft).
• The Next PG2 includes wall creep zone protection.
• In Next PG2 and Next K9-85 PG2, Target Specific Imaging™ (TSI) technology is used for distinction
between human beings and pets weighing up to 38 kg (85lb).
• Includes a fully supervised PowerG transceiver.
• The advanced True Motion Recognition™ algorithm (patented) allows distinguishing between the true
motion of an intruder and any other disturbances which may cause false alarms.
• Sophisticated frequency domain digital signal processing.
• Built-in link quality indicators; no need for the installer to physically approach the control panel thus making
installation faster and easier.
• No vertical adjustment is needed.
• Motion event counter determines whether 1 or 2 consecutive motion events will trigger an alarm.
• Automatic termination of walk-test after 15 minutes.
• Microprocessor-controlled temperature compensation.
• Sealed chamber protects the optical system.
• Front cover and back tamper switches, for improved tamper protection.
• White light protection.
• Notes: 1. The pet immunity feature was not evaluated by UL.
2. For CE installations, the pet immunity was not evaluated by DNV.
3. The pet immunity feature is not evaluated and certified by Applica Test & Certification AS.
2 2 2 2 . . . . INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION

2.1 General Guidance

1. Keep away from heat sources.
2. Do not expose to air drafts.
3. Do not install outdoors.
4. Avoid direct sunshine.
5. Keep wiring away from power cables.
6. Do not install behind partitions.
7. Mount on solid stable surface.
8. Installed in accordance with NEC, NFPA 70.
9. Installed in accordance with UL 681, Standard for
Installations and Classifications of burglar and Holdup
Alarm Systems.
Important! The Next K9-85 PG2 detector is tolerant to 38 kg (85 lb) animals moving on the floor or climbing on
furniture as long as the activity takes place below 1 m (3 ft). Above the 1 m (3 ft) height limit, the detector is tolerant
to 19 kg (42 lb) pets, but the pet immunity will decrease as the pet gets closer to the detector. It is therefore
recommended to select a mounting location that minimizes potential close proximity of animals.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the PIR detector should be located at a distance of at least 20
cm from all persons during normal operation. The antennas used for this product must not be co-located or operated in conjunction with any other
antenna or transmitter
D-302413 NEXT PG2, NEXT K9-85 PG2 Installation Instructions
85 PG2
85
85
PG2
PG2
PG2
(see Fig. 2)
Installation Instructions
A. LED
B. Lens
Figure 1: External View
1
2
4
5
7
Figure 2. General Guidelines
A
B
3
6
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NEXT PG2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Visonic NEXT PG2

  • Page 1 • Combined Fresnel and cylindrical optics, up to 15 meters (49 ft). • The Next PG2 includes wall creep zone protection. • In Next PG2 and Next K9-85 PG2, Target Specific Imaging™ (TSI) technology is used for distinction between human beings and pets weighing up to 38 kg (85lb).
  • Page 2 [2] Select the "Device Settings" option and refer to section 2.4 to configure the detector parameters. 2.4. Configuring the Detector Parameters DEVICE SETTINGS Enter the menu and follow the configuration instructions for the Next PG2 / Next K9-85 PG2 PIR detector as described in the following table. Option Configuration Instructions Alarm LED Here you determine whether or not the alarm LED indication will be activated.
  • Page 3 C. The Next PG2 / Next K9-85 PG2 will enter a 2 min. stability period. During this time the red LED blinks. D. Walk-test the coverage area - see Fig. 5. Walk across the far end of coverage pattern in both directions, The red LED lights each time your motion is detected followed by 3 LED blinks.
  • Page 4 Reported when a tamper event occurs and in any subsequent message, until the tamper switch is restored MOUNTING Height 1.8 - 2.4 m (6 - 8 ft). For Next PG2, the recommended height is up to 2.1 m (7 ft) Installation Options Surface or corner ACCESSORIES BR-1: Surface mounted swivel bracket, adjustable 30°...

This manual is also suitable for:

Nextk9-85pg2

Table of Contents