» Do not use with any opening » Do not allow to be used as a toy. » Keep appliance on a level surface. blocked. » Close attention is necessary when SAVE THESE INSTRUCTIONS FOR FUTURE USE This model is for household use only. www.BISSELL.com...
Thanks for buying a BISSELL BOLT® Lithium! We love to clean and we’re excited to share one of our innovative products with you. We want to make sure your vacuum works as well in two years as it does today, so this guide has tips on using (pages 6-9), maintaining (pages 10-13), and if there is a problem, troubleshooting (page 14).
Page 4
Release Trigger Pet and Debris Nozzle Brush Hand Vac Release Button Sweep and Scoop Tool Hand Vacuum Power Button Charging Adapter Plug Dirt Cup Release Crevice Tool with Dusting Brush Charging Light Indicator Charging Base Detachable Hand Vacuum Dirt Cup www.BISSELL.com...
Assembly WARNING Do not plug in your BOLT® Lithium until you are familiar with all instructions and operating procedures. Your BISSELL BOLT® Lithium vacuum • Handle comes in three easy to assemble • Body components and does not require any •...
Page 6
NOTE: The brush roll will be ON when the stick vacuum is turned ON. Having the brush roll ON may improve cleaning on soft surfaces such as low-pile area rugs. www.BISSELL.com...
Page 7
Operating 2-Way Folding Handle Find the 2-Way folding handle trigger Pull the trigger to fold the handle. located under the handle. Fold the handle forward to easily Fold the handle back for easy storage. clean underneath low places. www.BISSELL.com...
Page 8
Removable Hand Vacuum Press the button located on top of the Press the power button to begin hand vacuum handle and lightly pull out cleaning. to remove it from the machine. www.BISSELL.com...
Page 9
The charging base will recharge your stick vacuum and also store the tools. There are up to three spots to store the tools to your hand vacuum on the charging base. Reminder: The charging port on the base is located underneath. www.BISSELL.com...
Page 10
Empty the dirt cup into a waste clean off excess dirt and debris. receptacle. WARNING Do not operate your BOLT® Lithium with damp or wet filters or without filters in place. www.BISSELL.com...
Page 11
NOTE: You may rinse the filter and frame in warm water to clean. The filter and frame need to be 100% dry before reuse. The key to maximum performance is having a clean filter. Cleaning the filter after each use will help your vacuum operate at peak efficiency. www.BISSELL.com...
Page 12
Clean your pet brush roll as needed back on. Brush will function again and place back into the foot. after allowing time to cool down. NOTE: Make sure the brush roll cover tab is locked back into place to prevent breaking or faulty brush roll. www.BISSELL.com...
Page 13
-Cut wires from the PCB and wrap the wire ends with insulation tape. -Keep Battery Pack together – DO NOT separate individual batteries. For specific disposal instructions of batteries, please contact RBRC (Rechargeable Battery Recycling Corporation) 1-800-822-8837 or visit www.rbrc.com. -Discard remainder of product. www.BISSELL.com...
Please do performed by an authorized service representative. not return Thank you for selecting a BISSELL product. this product For any questions or concerns, BISSELL is happy to to the store. be of service. Contact us directly at 1-800-237-7691. www.BISSELL.com...
Service If your BISSELL product should require service: Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.
Need help?
Do you have a question about the BOLT 1954 SERIES and is the answer not in the manual?
Questions and answers