Philips AZ1005 User Manual

Philips cd radio cassette recorder user manual

Hide thumbs Also See for AZ1005:

User manual (26 pages)

Operating manual (26 pages)

Specification (2 pages)

Table Of Contents

Need help?

Do you have a question about the AZ1005 and is the answer not in the manual?

Questions and answers

Summary of Contents for Philips AZ1005

Page 1 AZ 1005 CD Radio Cassette Recorder AZ 1007...
Page 2 9 0 ! AC MAINS...
Page 3: Power Supply
CONTROLS TOP AND FRONT PANEL 1 Source selector - to select source of sound: CD-RADIO-TAPE and also the POWER OFF switch 2 VOLUME - to adjust volume level 3 DBB - Dynamic Bass Boost: for a more vivid bass response CASSETTE RECORDER: 4 PAUSE ;...
Page 4: General Operation
POWER SUPPLY AC MAINS 1. Check if the mains voltage as shown on the type plate on the base of the set, corresponds to your local mains voltage. If it does not, consult your dealer or service organisation. 2. If your set is equipped with a voltage selector, adjust it so that it matches with the local mains.
Page 5: Selecting A Different Track
CD PLAYER CD DISPLAY INDICATION – Cd: CD door open/scanning for CD. – Total track number: in stop mode. – Current track number: during CD play. – Current track number flashes: in Pause mode. – modes: when the respective mode is activated. SHUFFLE REPEAT –...
Page 6: Programming Track Numbers
DIFFERENT PLAY MODES: SHUFFLE/REPEAT The CD MODE button allows you to select 4 different play modes which can also be combined with a CD program. The modes can be selected or changed during playback and will flash for two seconds before playing your selected mode. 1.
Page 7: Cassette Recorder
CASSETTE RECORDER PLAYING A CASSETTE 1. Set the source selector to TAPE. 2. Press STOP•OPEN 9 / to open the cassette holder and insert a recorded cassette. 3. Close the cassette holder. 4. Press PLAY 1 to start playback. 5. Adjust the sound using the VOLUME and DBB controls. 6.
Page 8: Synchro Start Cd Recording
SYNCHRO START CD RECORDING 1. Set the source selector to CD. 2. Insert a CD and if desired, programme track numbers. 3. Press STOP•OPEN 9 / to open the cassette holder. 4. Insert a blank tape. 5. Close the cassette holder. 6.
Page 9: Precautions & General Maintenance
MAINTENANCE PRECAUTIONS & GENERAL MAINTENANCE • Place the set on a hard, flat surface so that the system does not tilt. • Do not expose the set, CDs, batteries or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
Page 10: Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.

This manual is also suitable for:

Az1007/13 Az1007/10 Az100717 Az1007/14 Az1007 Az1007/11 ... Show all