Address And Main/Sub Setting For Wireless Remote Controller - Daikin FFQ09Q2VJUFFQ12Q2VJUFFQ15Q2VJUFFQ18Q2VJURX09QMVJURX12QMVJURX15QMVJURX18QMVJU Service Manual

Field Settings
4.4 Address and MAIN/SUB Setting for Wireless Remote
Controller
Outline
Transmitter Wireless address switch
Set the wireless address setting switch (SS2) on the transmitter board according to the table below.
Board
Wireless address switch
(SS2)
MAIN/SUB switch
When using both wired and wireless remote controllers for 1 indoor unit, the wired remote controller
should be set to MAIN. Therefore, set the MAIN/SUB switch (SS1) of the transmitter board to SUB.
MAIN/SUB switch (SS1)
SS2
123
If setting multiple wireless remote controllers to operate in one room, perform address setting
for the receiver and the wireless remote controller.
If using both a wired remote controller and a wireless remote controller with 1 indoor unit,
change the MAIN/SUB switch of the transmitter board.
Unit No.
SS1
No.1 No.2
(S1935)
MAIN SUB
(R24062)
SiUS091628EA
No.3
(S1936)
(S1937)
(R24063)
(R24374)
Trial Operation and Field Settings