Table of Contents
Advertisement
Available languages
Available languages
TrOuBLeShOOTinG
If unit does not turn on - LCD does not illuminate:
• Depress POWER/FIRE button.
• Check and if necessary, replace battery.
If unit does not respond to key presses, replace the battery with a good quality 3 volt lithium battery.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality 3 -volt lithium
battery.
If target range cannot be obtained:
• Make sure LCD is illuminated.
• Make sure that the POWER/FIRE button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses
(lenses closest to the target) that emit and receive the laser pulses.
• Make sure unit is held steady while depressing the POWER/FIRE button.
NOTE:
The last range reading does not need to be cleared before ranging another target. Simply aim at the new target
using the LCD's reticle, depress the POWER/FIRE button and hold until new range reading is displayed.
Specifications, instructions, and the operation of these products are subject to change without notice.
13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TOUR V4 and is the answer not in the manual?
Questions and answers
Mein Bushnell summt **** wenn er gemessen hat und die Fahne wird **** eingekreist
The buzzing sound is caused by the JOLT technology in the Bushnell TOUR V4. When the rangefinder locks onto the flag, it gives two short vibrating bursts to confirm that the target has been acquired. The circle around the flag appears during this process to help with aiming.
This answer is automatically generated