Advertisement
Quick Links
N
L E I S U R E
BUILD-IN
COOKING HOB
MODELS H200F, H250F,
H400F, 756 & 854F
FOR USE WITH LIQUIFIED PETROLEUM GAS
USER AND INSTALLATION INSTRUCTIONS
WARNING
•
This appliance must be installed by an authorised person.
•
Only use this appliance in a well ventilated area.
•
Read the instructions before use.
FOR USE IN: - GB, IE, FR, NL, BE, LU, ES, IT, NO, DE, DK, SE
SPINFLO LIMITED, 19 Oakham Drive, Parkwood Industrial Estate
Rutland Road, Sheffield S3 9QY, ENGLAND.
TEL: + 44 (0) 114 273 8157
FAX: + 44 (0) 114 275 3094
Advertisement
Related Manuals for spinflo H400F
Summary of Contents for spinflo H400F
- Page 1 Read the instructions before use. FOR USE IN: - GB, IE, FR, NL, BE, LU, ES, IT, NO, DE, DK, SE SPINFLO LIMITED, 19 Oakham Drive, Parkwood Industrial Estate Rutland Road, Sheffield S3 9QY, ENGLAND. TEL: + 44 (0) 114 273 8157...
-
Page 2: Model Range
MODEL RANGE... -
Page 3: Installation Details
INSTALLATION DETAILS... - Page 4 INTRODUCTION This appliance must be installed in accordance with the local, national and European regulations in force. Particular attention shall be given to the requirements regarding ventilation. Read the instructions before installing or using the appliance The appliance is designed for either high or low level installations. Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution.
-
Page 5: Installation
– see installation details. Slide the grill box into place and fix it to the sides of the cupboard cut-out with 2 screws on each side. MODELS H200F/H400F - A minimum depth of 60mm from the top of the worktop surface must be provided for the hotplate A direct distance of 200mm must exist between the edge of the appliance burners and any combustible material, unless protected by a layer of non-combutible material. - Page 6 INSTALLATION If the flame on either the top burners or the grill show a tendency to lift, it is probable that the line pressure is too great. Should there be excessive yellow tips (resulting in sooting) then it is probable that the line pressure is too low and, in either case, the burners should not be used until the line pressure has been checked.
- Page 7 USER'S INSTRUCTIONS Using the Hob Burners Each burner is controlled individually and is monitored by a flame failure sensing device. The respective knob positions are shown HIGH RATE LOW RATE To light the burner, depress and turn the knob anti-clockwise to the full rate position, apply a light to the burner or press the ignition button if fitted.
- Page 8 USER INSTRUCTIONS Leaks If a smell of gas becomes apparent, the supply should be turned off at the cylinder IMMEDIATELY. • Extinguish naked lights including cigarettes and pipes. • Do not operate electrical switches. • Open all doors and windows to disperse any gas escape. •...
- Page 9 HOB SERVICE INSTRUCTIONS ALL SERVICING MUST BE CARRIED OUT BY AN APPROVED COMPETENT PERSON. AFTER EACH SERVICE THE APPLIANCE MUST BE CHECKED FOR GAS SOUNDNESS. Hob Burner Gas valve removal/replacement • Shut off gas supply and disconnect gas supply pipe from the unit. •...
Need help?
Do you have a question about the H400F and is the answer not in the manual?
Questions and answers