Table of Contents
Advertisement
Available languages
Available languages
BLADERUNNER
TROUBLESHOOTING
Symptom
Tool will not start when
switched on.
Poor cut quality
Work efficiency is low.
Blade is not clamped tightly by
the Blade Holder.
Blade Release button cannot
be pressed down.
Guard Arm vibrates too much.
Rip Fence cannot slide into
Fence Slot smoothly.
14
X2
®
Possible Causes
• Power cord is not plugged in.
• Blade is worn out.
• Blade is set incorrectly
• Too much vibration in
material.
• Too much vibration of the saw.
• Feed rate too fast.
• Blade is worn out.
• Feed rate too fast.
• Blade is not inserted into
place fully.
• Dust accumulates.
• Screws fixing the Guard
Arm on the work table are
loose.
• Rip Fence locking knob too tight.
Possible Solution
• Check to make sure power cord is connected
well into a working outlet.
• Make sure the blade is sharp and not broken.
• Make sure the blade is installed properly.
• Tighten Guard and Guard Arm firmly down
onto material.
• Clamp or fasten saw base to tabletop.
• Feed the material more slowly.
• Change to a new blade.
• Feed the material more slowly.
• Use blade grip to push the blade as far into
the blade holder as possible before letting go
of Blade Release.
• Clean the dust around the Blade Release button.
• Tighten the screws as shown in Fig A1.
• Loosen the Rip Fence locking knob.
ENG
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RK7323 and is the answer not in the manual?
Questions and answers
what assembly is required to make it functional
The Rockwell RK7323 BladeRunner X2 requires assembling components such as the steel rip fence, miter gauge, and blade before use. Accessories should be properly installed and secured according to the instructions. Additionally, safety guards must be in place and in working order.
This answer is automatically generated