Factory Hard Reset - dbx iEQ-15 User Manual

iEQ

Factory Hard Reset

In the event that you experience peculiar behavior with the iEQ or would like to set the Power-Up Mode
settings back to their factory default state, please perform the following Factory Hard Reset procedure:
• Power on the unit while pressing and holding the CHANNEL 2 <AFS> button until the
CHANNEL 2 meters display the LED pattern shown below, then release the button�
Power Up Prompt
• Press and release the CHANNEL 1 <AFS> button until the CHANNEL 1 AFS button LED
is lit Yellow�
• To perform the Hard Reset, press and hold the CHANNEL 2 <AFS> button until all
CHANNEL 2 meter LEDs begin to flash, then release�
• To exit and return to normal operating mode, press and hold the CHANNEL 1 <AFS>
button until all CHANNEL 1 meter LEDs begin to flash, then release� The unit will take a
few seconds to reboot and will then be ready to operate� All settings will now be back to their
factory default state�
The iEQ's factory default settings are as follows:
Power-Up Mode Menu
System Lockout
Live Filter Lift Time
AFS Normal vs� 6-Fixed/6-Live Mode
Technical Information
CHANNEL 2
Default Setting
Unlocked
Live Filter Lift Off
AFS Normal Mode
iEQ User Manual 13