Alarm Modes; Features And Functions - Tomy TDV450 Instructions Manual

71030 C5 UK 10 creep.indd Spread 3 of 32 - Pages(62, 3) 71030 C5 UK 10 creep.indd Spread 3 of 32 - Pages(62, 3)
62
• PARENT UNIT – BATTERY INSERTION
For portable use the Parent Unit is supplied with a rechargeable battery. To insert, remove the battery compartment
cover from the back of unit (N.B: this may already be supplied loose) and insert the battery pack correctly,
connecting the plug with the socket. Replace the cover and screw fi rmly into position, referring to the Quick Start
Guide for pictorial reference.
Ensuring the power cable is correctly connected, plug your Parent Unit into the mains supply and charge for a full
7 hours. You can use your monitor while it is charging by following the 'Set Up' guide below.
Important! Your Parent Unit will not function without fi rst inserting the battery.
• BABY UNIT – MAINS CONNECTION
The Baby Unit is mains (AC) powered only. Connect the unit to a suitably located domestic mains supply using one of
the supplied adaptors.
• SET UP
Make sure both Parent and Baby Units are plugged into the mains and/or the Parent Unit is adequately charged. The
units should stand at least 1 metre apart.
Press and hold the button on each unit for at least 2 seconds. Once activated, the
The Baby Unit Camera should be positioned to give a complete view of your baby. It may be wall mounted onto a wall
that over looks your sleeping baby in the cot, or stood upright on a fl at surface pointing towards your baby. Important!
Keep cot sides & ends at least 38cm (15 inches) from adjacent bedroom furniture.
• BABY AND PARENT UNIT CONNECTION
As each unit activates, watch for the animated sequence on the Parent
Units LCD screen as the units auto-search and link to each other.
Once a connection is made between Baby and Parent Units, audio and
video motoring will start.

• ALARM MODES

Identify the cause of an audible alarm by using the following table; should you be unable to identify or rectify the
cause of the problem, please refer to the Simple Solution Guide within this booklet.
Alarm tone on
Alarm Condition
Parent Unit
Loss of contact.
••••••••
(Continuous)
Search Animation
Sequence Icon
Low Battery –
•••
Parent Unit
3 beeps

• FEATURES AND FUNCTIONS

• VOLUME CONTROL
Adjust the volume from zero (mute) to level 8 (max) by pressing the
Sound Level Display on the Video screen shall be momentarily replaced with the adjusted volume level.
• SOUND LEVEL DISPLAY
The Sound Level Display on your Parent Unit reacts to the sounds of your baby. The louder your baby, the more lights
illuminate on the display. You can lower the volume of the Parent Unit whilst still watching out for baby, ideal for when
you're relaxing or entertaining.
GB
button will glow.
Activation Sequence
Indications on the
Indications on the Parent Unit
Baby Unit
• Flashing search animation sequence. • Button will change from
solid green to alternating
(continuous) fl ashing green
and red.
• The battery icon will fl ash.
• Button will change from
green to fl ashing red.
(left) and (right) arrow keys as necessary. The
3
26/2/10 14:41:08 26/2/10 14:41:08