Operating The Remote Control; Setup The Remote; Pairing The Remote - Brookstone LYSB018BAARGW-ELECTRNCS Manual

OPERATING THE REMOTE CONTROL

SETUP THE REMOTE

1. Install included (2) AAA batteries in the remote control.
• Turn the remote control over and locate the battery door on the rear of the unit.
• Press on the remote door arrow and slide in the direction indicated by the arrow.
• Insert batteries as pictured on the inside of the battery compartment.
IMPORTANT: Insert batteries negative (-) side first into the slots , pushing it into the coil
and then into the compartment. Do not insert batteries positive (+) side first.
• Place battery door over compartment, lining up the door tab with the opening on the
remote. Slide the door until it securely snaps into place.

PAIRING THE REMOTE

The projector is primarily controlled through the included remote.
IMPORTANT: The distance between the remote and the projector should be 6.5 feet or less.
12