Makita M3601 Instruction Manual page 7

1
Fig.9
► 1. Feed direction 2. Bit revolving direction
3. Workpiece 4. Straight guide
Straight guide
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Fig.10
To install the straight guide, insert the guide bars into
the holes in the tool base. Adjust the distance between
the bit and the straight guide. At the desired distance,
tighten the wing bolts to secure the straight guide in
place. When cutting, move the tool with the straight
guide flush with the side of the workpiece.
1
Fig.11
► 1. Guide bar 2. Clamp screw 3. Straight guide
2 3
4
3
2
If the distance (A) between the side of the workpiece
and the cutting position is too wide for the straight
guide, or if the side of the workpiece is not straight, the
straight guide cannot be used. In this case, firmly clamp
a straight board to the workpiece and use it as a guide
against the trimmer base. Feed the tool in the direction
of the arrow.
A
Fig.12
Dust nozzle set (For European
countries only)
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the
tool base. Then connect a vacuum cleaner to the dust
nozzle.
1
Fig.13
► 1. Dust nozzle 2. Thumb screw
Fig.14
7 ENGLISH
2