Table of Contents
Advertisement
2.4 DIA-250 S MOUNTING INSTRUCTIONS
ADESIF POLYESTER FRONT
IS
roupe
1 – Cut out the panel according to the values above
2 – Fasten the face-plate on to the panel using countersunk screws.
3 – Place the keypad ribbon cable in the face-plate slot, then fasten the plaque.
Connect the ribbon cable to connector « P4 » of the telephone card (see page 15)
4 - Pass the line cable through the cable-entry, leaving sufficient length for connection.
Connect the telephone line on to terminal BR1 of the telephone card (see page 16)
5 – Clip the backing-case on to the face-plate.
250S-UK1.DOC
PARTITION SIDE
3
14 / 32
FRONT PLATE
1
BACKING CASE
5
4
CABLE ENTRIES
FOR CABLE
Diam.3 TO 20.5mm
2
Advertisement
Table of Contents
