Table of Contents
Advertisement
Menu Item
Description
Rate Control
This is the output rate control.
Parameters
Auto - The output rate follows that set by the uplink. This
setting can be used if the signal source is ASI. If Insert Null
Packet is set to Yes, the output bit rate is the same as the
input rate (including all the null packets). If Insert Null
Packet is set to No, and the Output Mode is set to one of
the MPTS modes, the output rate is equal to the payload
rate of the transport stream to be encapsulated, and in most
cases, it will be lower than the overall input rate.
User - The output rate is specified by the User Rate (Mbps)
parameter. It is determined by the user setting, regardless
of the input source. Null packets are always inserted when
the configured output bit rate is higher than the payload
rate of the transport stream to be encapsulated.
Setup Menu
119
Advertisement
Table of Contents
