Rear Drum Brake Drum - Subaru 2001 FORESTER Service Manual

Brake

9. Rear Drum Brake Drum

A: REMOVAL
S405180A18
1) Loosen wheel nuts, jack-up vehicle, support it
with safety stands, and remove wheel.
2) Release parking brake.
3) Remove brake drum from brake assembly.
NOTE:
¼ If it is difficult to remove brake drum, remove
adjusting hole cover from drum, and then turn
adjuster assembly pawls using a slot-type screw-
driver until brake shoe separates from the drum.
(1) Back plate
(2) Wheel cylinder
(3) Adjuster ASSY pawls
(4) Adjusting lever
(5) Tightening direction
(6) Push.
¼ If brake drum is difficult to remove, drive it out by
installing an 8-mm bolt into bolt hole in brake drum.
REAR DRUM BRAKE DRUM
B: INSTALLATION
S405180
1) Set the outside diameter of brake shoes less
than 0.5 to 0.8 mm (0.020 to 0.031 in) in compari-
son with the inside diameter of brake drum.
2) Install drum.
C: INSPECTION
1) If the inside surface of brake drum is streaked,
correct the surface. And, if it is unevenly worn,
taperingly streaked, or the outside surface of brake
drum is damaged, correct or replace it.
2) Measure the drum inner diameter.
Drum inner diameter: "L"
S4M0369A
B4M0243
BR-34
S405180A11
S405180A10
Standard 228.6 mm (9 in)
Service limit 230.6 mm (9.08 in)
G4M0403