Page 1
T O Y O T A N A V I G A T I O N S Y S T E M Avensis (RHD) INSTALLATION INSTRUCTIONS ** T25 * R PART NUMBER PZ425-T0330-60 MOUNTING BRACKET KIT PZ445-T9281-00 RDS-ANTENNA KIT 08545-20800 NAVIGATION KIT see page 7 ADDITIONAL PARTS Manual Ref. Nr. D3RT25/W-0-0 TOYOTA MOTOR CORPORATION...
Avensis (T25) TNS300ETA PRECAUTIONS PLEASE READ THOROUGHLY THESE PRECAUTIONS BEFORE THE INSTALLATION • Be sure to disconnect the negative • Protect your car with fender covers, seat (-) lead from the battery terminals. and so on. • Do not pinch the rear wiring or har- •...
Avensis (T25) TNS300ETA RDS-ANTENNA KIT PZ445-T9281-00 Part name Part No. Quantity Antenna strip PZ445-E9281-01 RDS antenna wire PZ445-T9281-01 Ground bolt Fakra connector PZ445-E9330-01 (1): For vehicles without pre-wired RDS-antenna. REQUIRED PARTS NAVIGATION DISC To be ordered separately. Please refer to the list of available DVD-ROM for TNS300 Navigation Systems (Access to accessories).
Avensis (T25) TNS300ETA ADDITIONAL PARTS Part name Part No. Quantity Bracket cover 86804-32010 RDS-Tuner PZ445-E9330-02 Subwire harness PZ445-E9330-03 Extension wire PZ445-T0210-60 GPS antenna 08663-00811 Earth plate 08674-00810 Wire tie (2): For vehicles without pre-wired GPS-antenna. (3): For vehicles without pre-wired connector.
Avensis (T25) TNS300ETA VEHICLE DISASSEMBLY FOR M/T MODELS Remove the shift knob FOR ALL MODELS Remove the shift hole cover : Clip (4x) Fig. 1 Remove the instrument panel cluster moulding : Clip (5x) Fig. 2 Remove the console panel...
Page 11
Avensis (T25) TNS300ETA Remove the rear console heater panel as shown using bolts (2x). : Bolt (2x) : Clip (4x) Fig. 4 Remove the cover of the midconsole : Bolt (2x) : Screw (4x) Fig. 5 Remove the heater control assembly : Bolt (4x) Fig.
Page 12
Avensis (T25) TNS300ETA Remove the multi display : Screw (2x) : Clip (2x) Fig. 7 Remove the front door scuff plate (L). : Hook (6x) Fig. 8 10. Remove the kick panel (L) : Nut (1x) : Hook (2x) Fig. 9...
Page 13
Avensis (T25) TNS300ETA 11. Remove the glove box : Bolt (1x) Fig. 10 Remove the passenger and driver side sun visor holder by turning it 90° counterclockwise. Remove the passenger side sun visor : Clip (2x) : Screw (2x) Fig. 11...
Page 14
Avensis (T25) TNS300ETA 14. Remove the map lamp cover : Clip (6x) Fig. 13 15. Release the map lamp assembly : Screw (2x) Fig. 14 16. Remove the passenger side front pillar garnish : Clip (2x) CAUTION First release the clip at the inner side of the pillar.
Avensis (T25) TNS300ETA INSTALLATION OF THE GPS ANTENNA Cut the foam (d) into 8 large pieces and 2 small pieces as shown in the illustration. : Foam tape (8x) : Foam tape (2x) Fig. 17 Cut one butyl tape into 2 equal sized pieces.
Page 17
Avensis (T25) TNS300ETA Centre Attach the earth plate to the multi display as shown and mount the GPS antenna to the earth plate CAUTION When affixing the earth plate make sure to carefully wipe of any dirt, moisture or oil from the surface of the location where it is to be affixed.
Avensis (T25) TNS300ETA WIRE HARNESS INSTALLATION Disconnect the 18P connector of the vehicle wire harness as shown. WIRE SIDE VIEW Fig. 22 Connect the 18P connector of the extension wire to the vehicle wire harness Attach the extension wire and GPS...
Avensis (T25) TNS300ETA INSTALLATION OF THE RDS ANTENNA WIRE If not yet insulated, insulate the com- plete ground wire of the RDS antenna wire by wrapping it into tape ground wire Fig. 25 Cut off the indicated area of the lip of the RDS-antenna using scissors.
Page 20
Avensis (T25) TNS300ETA Route and attach the RDS antenna wire along the instrument panel to the vehicle wire harness as shown using wire ties : Wire tie (2x) Fig. 28 Route the RDS antenna wire along the front door scuff plate area through...
Avensis (T25) TNS300ETA INSTALLATION OF THE RDS ANTENNA Thoroughly clean the mounting sur- face of the front window to which the antenna strip is to affixed. centre Remove the release paper of the antenna strip 70 mm 20 mm Attach the antenna strip to the front window as shown.
Page 22
Avensis (T25) TNS300ETA centre ONLY FOR VEHICLES WITHOUT RAIN SENSOR CAUTION Be sure the top side of the joggle is pushed against the body of the roof. Antenna joggle Fig. 32 Route the ground wire of the RDS antenna as shown.
Avensis (T25) TNS300ETA INSTALLATION OF THE TNS COMPUTER + ETA Slit the floor carpet according to the measurements as shown. Remove the button by turning it 30 mm counterclockwise. 20 mm 30 mm Fig. 34 Attach the navigation ECU-brackets (a) and...
Page 24
Avensis (T25) TNS300ETA Connect the 1P and 8P connector of the navigation harness to the naviga- tion ECU Connect the navigation harness 13P female connector to the subwire har- ness 13P male connector. Connect the 13P subwire harness connector to the navigation ECU...
Page 25
Avensis (T25) TNS300ETA Push the bracket (a) of the naviga- tion ECU with RDS-Tuner into the slit on the floor under the passen- ger seat as shown. CAUTION When affixing the navigation ECU make sure to carefully wipe off any dirt, moisture or oil from the surface of the location where it is to be affixed.
Avensis (T25) TNS300ETA INSTALLATION OF NAVIGATION DISC Connect the battery and turn the igni- tion switch to the ACC position. Slide the eject switch on the computer to the left to open the disc insertion slot. With the label side of the disc facing up, insert the Navigation Disc into the disc insertion slot.
4. Perform the “auto-compensation” procedure by following the section on “When Tires are Replaced” in the TNS300 Owner’s Manual. When an abnormality is suspected, perform troubleshooting based on the “Toyota Genuine Navigation System Service Manual”. REASSEMBLING Return all vehicle parts that have been removed to their original locations. Especially make sure to attach trim and other inte- rior materials properly so that they do not have a detrimental effect on the function of the vehicle.
Need help?
Do you have a question about the TNS300ETA and is the answer not in the manual?
Questions and answers