Types Of Work; Locking The Chisel; Setting The Chiseling Power - Hilti TE 700-AVR Operating Instructions Manual

▶ Set the function selector switch to

5.6 Locking the chisel

▶ Set the function selector switch to

5.7 Setting the chiseling power

Note
Chiseling power can be reduced to approx. 70% by pressing the power
level selector switch. The power level LED then lights up, indicating
reduced power.
Chiseling power can be adjusted only when the power tool is switched
on and ready for use. To reselect full chiseling power, press the chiseling
power level selector switch again. Switching off and then on again also
causes the power tool to return to full chiseling power.
▶ Press the power level selector switch.

6 Types of work

WARNING
Risk of electric shock! Severe injury and burns can result if any
attempt is made to operate the tool without an earth/ground conductor
and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used,
always make sure that an earth/ground conductor and ground fault
circuit interrupter are present in the power supply and that these are
correctly connected.
▶ Do not use the product unless these safety measures are in place
and fully operational.
Observe the safety instructions and warnings in this documentation and on
the product.
Printed: 02.02.2017 | Doc-Nr: PUB / 5270002 / 000 / 01
and position the chisel as desired.
and rotate the chisel until it engages.
English 15