Cool Pad - Rotem Platinum Plus User Manual

D D o o c c . . N N a a m m e e : : P P + + U U s s e e r r M M a a n n
2.2

Cool Pad

Set operating conditions for Cool Pad. (Only operates in Tunnel mode)
Menu
• Day: Set Growth Day
• Start Time & End Time: Set time of day you want the cool pad to start and stop
o It is possible to set multiple start and stop times for a single day.
o In the screen above, growth day jumps from day 1 to day 10, the cool pad will
continue to work according to day 1 settings until growth day 10.
• Tunnel Differential: Set difference from tunnel temperature to trigger cool pad.
• To Humidity: Set maximum humidity allowed before stopping cool pad.
• On Sec & Off Sec: Set the cycle in seconds for cool pad operation.
NOTE: In order to disable humidity, set to 100 or 0. If humidity does not exist, controller
ignores this column.
2.2.1 C P HELP | SET
OOL AD
Help
HELP | SET Definitions:
• Temperature Band: Define the scope for on/off of cool pad relative to target temperature.
• Humidity Band (%): Define the scope for on/off of cool pad relative to humidity inside.
• Flush Cool Pad At: Set time of day (hh :mm) to start a continuous application of water to the
cool cells in order clean them of debris.
• Cool Pad Flush Duration (minutes): Set the length of time in minutes for flushing.
u u a a l l - - S S t t a a n n d d a a r r d d C C h h a a p p t t e e r r : : D D e e v v i i c c e e
6. Cool Pad
Enter
Enter
R R e e v v i i s s i i o o n n : : B B
Platinum Plus
P P a a g g e e : : 1 1 4 4