Wireless Networks; Maintenance; Firmware Maintenance - Funkwerk R1202 Reference Manual

Funkwerk Enterprise Communications GmbH
bintec Rxxx2/RTxxx2
For each adjacent AP, you see an entry with a parameter set ( Detected via AP, MAC Ad-
dress, SSID, Signal dBm, Channel, Last Seen; under Detected via AP you see the re-
spective device location).
Click under New Neighborscan on Start, to rescan adjacent AP's. You will receive a warn-
ing that the wireless modules of the access points must also be disabled for a certain peri-
od of time. When you start the process with OK, a progress bar is displayed. The located
AP display is updated every ten seconds.

13.4.3 Wireless Networks

Wireless LAN Controller
Fig. 70:
In menu Wireless LAN Controller->Monitoring+Wireless Networks an overview of the
currently used AP is displayed. You see which wireless module is assigned to which wire-
less network. For each wireless a parameter set is displayed (Location, VSS, MAC Ad-
dress (VSS), Channel, Clients).

13.5 Maintenance

This menu is used for the maintenance of your managed APs.

13.5.1 Firmware Maintenance

Wireless LAN Controller
Fig. 71:
Monitoring Wireless Networks
-> +
Maintenance Firmware Maintenance
-> ->
13 Wireless LAN Controller
181