Connecting To A Tv Equipped With Component Video Inputs - Toshiba RD-XS32SB Owner's Manual

Connections

Connecting to a TV equipped with component video inputs

If your TV has component video inputs, you can obtain pictures in better quality.
To P
OUTPUT
To audio
inputs of the
amplifier
(red)
Component video outputs/inputs
Some TVs or monitors are equipped with component
video inputs. Connecting to these inputs allows you to
enjoy higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex.Y, R-Y, R-B or
Y, C , C )
B R
In some TVs or monitors, the color levels of the
playback picture may be reduced slightly or the tint
may change. In such a case, adjust the TV or monitor
for optimum performance.
To switch the output signal (Progressive/Interlaced)
Press PROGRESSIVE on the remote control.
PROGRESSIVE
The output signal alternates between
component progressive and component
interlaced.
• If the recorder detects any data that indicates
the contents are copy protected, it may not
output the contents in the progressive format.
Notes
• Refer to the owner's manual of the connected TV as well.
• When you connect the recorder to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before any connections.
• If you place the recorder near a tuner or radio, the radio broadcast sound might be distorted. In this event, place the recorder
away from the tuner and radio.
• The output sound of the recorder has a wide dynamic range. Be sure to adjust the amplifier's volume to a moderate listening
level. Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the recorder's power cord. If you leave the amplifier power on, the
speakers may be damaged.
VIDEO
B
To Y VIDEO
OUTPUT
To ANALOG To ANALOG
AUDIO OUTPUT AUDIO OUTPUT
(R: red) (L: white)
Audio cable (not supplied)
(white)
TV or monitor
equipped with
component
video inputs
To P VIDEO
R
OUTPUT
Video cable
(not supplied)
To P
To P
To Y video input
• The following setting is required according to the TV
that you are connecting. Perform this setting after step
4 ( page 15).
Setting "AV1 output" on the
"Initial settings" menu.
TV
TV or monitor
equipped with
component video
inputs
• Selecting "RGB" disables signal output from the VIDEO
OUT (Y, P , P ) jacks. If the on-screen display
B R
disappears immediately after you select "RGB", you
can restore it by connecting the recorder using the
VIDEO OUTPUT (yellow) jack.
video input
R
video input
B
"Audio out select" on the
"Picture/Audio settings"
page 43 menu.
"Video" or "S-Video" "Analog 2ch"
page 48
17