Subscribe to Our Youtube Channel
Related Manuals for Fat Shark TELEPORTER V3 RTF FPV KIT
Summary of Contents for Fat Shark TELEPORTER V3 RTF FPV KIT
- Page 1 Fat Shark RC Vision Systems TELEPORTER V3 RTF FPV KIT USER MANUAL Revision A 07/13/2013 For more product information, please visit: www.fatshark.com All Rights Reserved...
-
Page 2: Table Of Contents
Warranty ........................ 12 Introduction Congratulations on purchasing the Fat Shark Teleporter V3 RTF FPV video piloting system with goggles, transmitter and HD camera. To ensure your continued enjoyment, please take the time to thoroughly read through this operating manual before using. -
Page 3: Product Contents
Fat Shark RC Vision Systems Product contents Carry case Teleporter Headset FPV Downlink Kit (HD camera, TX, filter) AV cable 5G8 Antenna (TX, RX) Battery (with discharge adapter Manual... -
Page 4: Controls Diagram
Fat Shark RC Vision Systems Controls Diagram... -
Page 5: Controls
Simply connect the balance lead of your 2S, 3S or 4S (7.4V, 11.1V, 14.8V) RC battery to provide power to your Fat Shark Downlink and you are ready to fly. The handy balance lead filters RC servo and motor noise from your RC pack for a... -
Page 6: Transmitter
Fat Shark RC Vision Systems Transmitter Channel select chart: Ch1 5740 MHz Ch2 5760 MHz Ch3 5780 MHz Ch4 5800 Mhz Ch5 5820 MHz Ch6 5840 Mhz Ch75860 MHz WARNING: DO NOT POWER TRANSMITTER WITHOUT ANTENNA ATTACHED. NO ANTENNA LOAD WILL CAUSE DESTROY TX RF AMPLIFIER –... -
Page 7: Power (Via Discharge Filter Supply)
Fat Shark RC Vision Systems Power (via discharge filter supply) The discharge filter supply allows you to power your downlink equipment from your onboard RC pack. Connect as shown below: AV in/out Port Ground Video AudR RCA Connector: Yellow: Video, White: Audio... -
Page 8: Accessories
Fat Shark RC Vision Systems Note (1): If the charger fails to announce charge complete, but is showing battery voltage at 8.4V, the charge can be considered finished. DO NOT LEAVE BATTERY ATTACHED TO CHARGER WHEN CHARGER IS NOT PLUGGED IN. -
Page 9: Specifications
Fat Shark RC Vision Systems Specifications Headset Specifications Optics: FOV 25 degrees diagonal Interpupillary (IPD) distance: 63.5mm (fixed) Optional diopter lens inserts available in -2, -4, -6 dpt Audio: Stereo User Controls: Channel selection ... -
Page 10: Camera Specifications
Fat Shark RC Vision Systems Camera Specifications: Camera board: 1/2.5” 5MP digital CMOS imager 720p (1280x720), 30 fps, 15Mbps AVI file, MJPG compression MicroSD support to 32Gb card Power: 5V (powered off TX) Power consumption: 250mA @5V ... -
Page 11: Operational Advice
Fat Shark RC Vision Systems Operational advice For best performance, select a channel that has the least amount of interference. While the transmitter is turned OFF, turn on the video headset and look at the screen as you check each channel. -
Page 12: Trouble Shooting
We also run a support forum for all technical issues at: http://fpvlab.com/ SPONSORS GATE/ FAT SHARK Post your questions there and they will be answered by our technical staff or peers. SYNERGY POSITIONING SYSTEMS...
Need help?
Do you have a question about the TELEPORTER V3 RTF FPV KIT and is the answer not in the manual?
Questions and answers