Page 1
The high rotation speed has enabled you to fasten screws as quick as lightning. pecifications The following electrical data are common to 6823, 6824 and 6825. Continuous Rating (W) Voltage (V) Cycle (Hz) Max. Output(W)
6823, 6824, 6825 Comfortable soft grip. Grip with ideal figure to press the machine along the spindle axis for driving properly. Higher rotation speed Convenient retractable carry for quick boarding. hook for temporarily hanging *Higher rotation speed has enabled you the machine.
Page 3
1.3Kg(3.0lbs) 1.4Kg(3.1lbs) 1.4Kg(3.1lbs) Products with no load speed 0 - 2,500 rpm. Competitor MAKITA Manufacturer Model No. 6823 6800DBV Mod.C Power Input (W) Current (A) under 120V (UL and CSA spec.) No load speed (rpm.) 0 - 2,500 0 - 2,500...
Page 4
epair < 1 > When installing ring 20, its grooved surface has to be in contact with spindle. (see Fig.1.) Grooved surface This side has to be in Surface without groove contact with spindle. Ring 20 Fig.1 Thrust needle bearing 821 <...
Page 5
< 4 > When replacing carbon brush, be sure if it is installed on motor housing properly. And then install handle cover onto motor housing. (see Fig.4.) < Properly installed carbon brush> <Incompletely installed carbon brush> Correct with your finger to install properly.
Page 6
< 6 > Makita grease No.1 have to be applied to the parts illustrated below. (see Fig.6 and Fig.6A.) (6823TP) Clutch (4.0 g) Gear section (2.0g) Thread section Thrust needle bearing Outer surface Needle bearing of Spindle Hole for Pin...
Page 7
< 7 > Removing and assembling gear housing cover (Removing) Loosen pan head screw M4x8. Pulling out gear housing cover from motor housing by approx. 10mm. Remove gear housing cover from motor housing. (Assembling) Assemble gear housing cover on motor housing with being careful not to damage lead wires. Fasten it on motor housing with pan head screw M4x8.
(6823) Black Brush holder Brush holder Blue Black White White Switch Noise <Note> suppressor Noise suppressor is not used in some country. Power supply cord (6824, 6825) Black Brush holder Brush holder Orange Purple Black White White Switch Noise <Note>...
Page 9
(6823) Wiring in upper part of switch Hold Lead wire (black) connecting field and switch in the lead holder. Hold Lead wire (red) of Hold lead wire (black) of field brush holder in the lead holder. in the lead holder.
Page 10
iring (6824TP, 6825TP) Wiring in upper part of switch Hold Lead wire (black) connecting field and switch in the lead holder. Hold lead wire (black) of field Hold Lead wire (orange) of in the lead holder. brush holder in the lead holder. Slack of the lead wires Hold lead wire (black) of field has to be limited in this area.