one. Speaker Placement Subwoofer Satellites Start with the subwoofer as close to one of the front cor- ners as possible to take advantage of solid-angle gains. If you get too much bass, adjust the ”VOLUME” towards ”MIN”. The result will be lower distortion and higher reliability.
two. Speaker Connections Separate and strip the ends connected to which termi- Connection Tips of the speaker wire as nal. It is important to con- shown. Speakers and ampli- nect all the speakers identi- fiers/receivers have corre- cally: (+) on the speaker to sponding (+) and (–) termi- (+) on the amplifier and (–) nals.
Line Level If your receiver has sub- woofer output jacks, you may connect the Alpha Junior Sub using this method. Note: Some receivers/ amplifiers have a single (mono) subwoofer output. In this case, it is recommended that you use a “Y”-connector (not included) to maximize the subwoofer’s perfor-...
Troubleshooting If there is no sound from If there is no sound com- If there is low bass output, any of the speakers, ing from one speaker, check the following: check the following: check the following: • Make sure the connections •...
Page 7
Alpha Home Cinema System Specifications Alpha 05 Satellite/Center Channel L.F. Drive Unit: 110 mm (CMMD cone/rubber surround) Tweeter: 10 mm (polycarbonate dome) Frequency Response: 80 Hz – 22 kHz Sensitivity: 88 dB Nominal Impedance: 8 ohm Crossover Frequency: 3.5 kHz Recommended Amplifier: 10 –...
Page 8
Declaration of Conformity We, Harman Consumer Inte national 2, route de Tours 72500 Château-du-Loir France declare in own responsibility, that the p oduct described in this owner’s manual is in compliance with technical standards: EN 55013/A12:1994 EN 55020:1994 EN 55022:1994 class B EN 61000-3-2:1995 EN 61000-3-3:1995 Robin Marshall...
Need help?
Do you have a question about the ALPHA and is the answer not in the manual?
Questions and answers