Connecting Wires To Terminals - Kenwood DMX7017DABS Instruction Manual

Ñ

Connecting wires to terminals

Accessory 1
Light Blue/Yellow
(Steering remote control wire)
Blue/White
[1]
(Power control/ Antenna control wire)
Brown
(Mute control wire)
Purple/White
(Reverse sensor wire) (2 m)
Light Green
(Parking sensor wire) (2 m)
For best safety, be sure to
connect the parking sensor.
[1] [2]: Blue/White wire is provided two wires, [1] and [2]. Blue/White wire total output ([1] + [2]): 12 V = 350 mA
Fuse (15A)
STEERING WHEEL
REMOTE CONT
REMOTE INPUT
P. CONT ANT CONT
MUTE
REVERSE
PRK SW
A: Black (Ground wire)
B: Yellow (Battery wire)
C: Red (Ignition wire)
A B C
If no connections are made, do not let
the cable come out from the tab.
To steering remote
To use the steering wheel remote control feature,
you need an exclusive remote adapter (not supplied)
matched to your car.
Connect either to the power control terminal when
using the optional power amplifier, or to the power
terminal for the booster amplifier of the film-type or
short pole type antenna.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
Connect to vehicle's reverse lamp harness when using
the optional rear view camera.
Connect to the vehicle's parking brake
detection switch harness.
Connection/Installation
Connector A
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Connector B
English
79