Samsung AC018KNZDCH/AA Service Manual page 45

Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and
follow the directions below.
1) Press the and
displayed.
2) Press the / button to select
3) Press the / button to select
code setting screen.
The first digit represents the page number and the remaining five digits are installation option.
NOTE
The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
4) Press the / button to set the installation option code in order. Press
next page.
SGE1 SGE2
0 2
SEG7 SEG8
1 RESERVED
SEG13 SEG14
2 External control
SEG19 SEG20
Individual control
3 of a remote
controller
Samsung Electronics
buttons at the same time for more than 3 seconds and then a Main menu will be
and then press
and then press
SGE3
RESERVED
SEG9
RESERVED
SEG15
External control
output
SEG21
Heating setting
compensation
button to enter a Sub-menu setting screen.
button to enter a Indoor unit installation option
SGE4
Exterior
temperature Central control
sensor
SEG10
Use of Heater RESERVED
SEG16
RESERVED
SEG22
RESERVED RESERVED
button to go to the
SGE5 SGE6
RESERVED
SEG11 SEG12
Master / Slave
SEG17 SEG18
Buzzer RESERVED
SEG23 -
-
Troubleshooting
4-13