Table of Contents
Advertisement
3.3 Before starting up
Before starting up, following items must be checked.
Check the screws and bolts at the machine and tighten if necessary. See table with
recommended torque settings in section "Service and maintenance":
Breddningsvingen
Check that all protective devices are undamaged and correctly attached to the equipment.
monteras på
insidan av
Lubricate the machine (see section "Service and maintenance").
maskinen
Check the oil level in the gearbox. The oil should reach the lower plug at the side of the
gearbox. The gearbox is filled with SAE 80W/90 API GL4/GL5 (ISO VG 220) gear oil.
Adjust height of scraper steel with support pads, and machine tilt with top link (see section
"Adjustments")
Check that no objects have wrapped themselves around moving parts.
Perform a trial run of entire machine.
3.4 Adjustments
Warning!
No work is allowed unless the equipment is safely secured (don't completely rely on
tractors 3-point connection).
Be careful when undoing the pierced rod of flap control, crushing hazard!
At any time when performing repairs and maintenance, the engine must be switched off
and the PTO shaft disconnected. Withdraw the ignition key from the switch.
trejonindustries.se
Instructions for Use and Maintenance 151-191 (1310)
17
Advertisement
Table of Contents
