Attaching The Fixing Clamp (D) - Hitachi TT-251 User Manual

Attaching the Fixing Clamp (D)

5
If you are installing to the edge of the table, use the fixing clamp (D) to prevent the projector from falling.
Screws to use: M4x12 hexagon head screw x 2 (To fix the fixing clamp (D))
Tightening torque: 0.98 N•m (10 kgf•cm)
Remove the two
M4 x 12 hexagon
head screws.
※ｔ
※t: Fixable if thickness of the table
is 25-50mm
■ Never use screws other than those designated.
Failure to heed this warning may cause the projector to fall or other hazard resulting in damage or injury.
■ Make sure to use the fixing clamp (D) when installing at the edge of the table.
■ Do not use at location where there is a risk of the unit falling.
■ Precautions should be taken to prevent toppling when placing the unit without using the fixing clamp (D) at
location where there is no risk of falling, such as on the floor.
■ Do not drag the tabletop use kit while it is on the table.
■ Hold the base plate and handle while carrying.
TT-251
M4x12 hexagon
head screw x 2
(D)
Lastly, turn the knob to ensure that the base plate
(B) is fixed by the fixing clamp (D).
WARNING
CAUTION
Handle
7
(B)
Base plate