Troubleshooting - Margaritaville DM3500 Series User Manual

4.
To remove the Ice Deflector Blade Assembly:
a.
turn the Shaving Blade Assembly Ring
counterclockwise until removed.
b.
pull off Ice Deflector
c.
remove Blade
RinSe all coMponentS With WaRM Soapy WateR
anD DRy befoRe Re-aSSeMbling.
cleaning the chaMbeR
1.
To Remove Lid:
flip latches down on both sides. remove Lid.
(Drink Dispenser and Remix Chamber remain attached.)
2.
Wash with warm, soapy water, or place on top track of the
dishwasher.
RecoMMenDation: RinSe WaRM WateR thRough nozzle
inSiDe DRink DiSpenSeR.
3.
To Clean Chamber and Remix Channel:
a.
remove Drink Dispenser by pressing upwards
on slanted side wings. it is a tension fit and will
pop up with upward movement.
b.
turn Chamber upside-down, unscrew collar
by turning counterclockwise.
c.
Remix Channel Blade stays attached to collar. the whole
thing can be pulled out as a unit. do not try and detach
two separate parts.
4.
Unscrew large collar from Chamber by turning
counterclockwise. remove Collar, Blending Blade and
Blending Sealing Ring.
note: blaDeS aRe ShaRp. hanDle With caRe!
-10-

tRoubleShooting

Shaving blaDe
DoS anD Don'tS
Drink Dispenser
Chamber with
Remix Channel
if the power indicator light does not light:
check that the unit is plugged into a working power outlet.
if liquid leaks from the base of the chamber:
remove it from the unit and check that the Blending Blade Sealing Ring
is properly installed and that the Chamber is tightened.
if water leaks from the unit:
empty the Ice Melt Reservoir and make sure reservoir is in place.
if the chamber overflows during the Shave 'n blend™ cycle:
follow the drink recipes included in "Making frozen Drinks" section and make
sure to not exceed the specified total volume.
if the chamber will not sit on the blending base:
remove it from the unit and check for ice on the Base.
WARnInG: unplug the unit before removing ice from the Blending Base.
if the shaver does not shave sufficient ice for the liquid in the blending jar:
check that the number of Drinks Rotary Switch setting corresponds to the
amount of liquid in the chamber.
if the drink is too watery: Make sure to follow the Recipe Guide (pg.6) or manually
shave more ice until the desired consistency is achieved.
Do not place fingers into the Chamber, Remix Channel or Ice Hopper. the blades
in this unit are sharp and could cause injury.
Do not place Chamber onto Blending Base while motor is running. the spinning
Blending Base could damage the Chamber.
Do not twist Chamber when removing. simply lift and remove. twisting the
Blending Jar could loosen the Blending Jar Base causing it to leak.
Do not put hot liquid into the Chamber. hot liquids could be ejected during the
blending process causing injury.
Do not place ice, frozen foods or very cold liquids into a Chamber which has come
directly from a hot dishwasher. the sudden change in temperature could cause the
Chamber to crack.
Do not place very hot liquids or foods into a Chamber that has come directly from
the freezer. the sudden change in temperature could cause the Chamber to crack.
Do follow the Cleaning and Maintenance instructions prior to your first use.
Do unplug the unit when not in use.
-11-