Page 3
WARRANTY We provide with 12 months warranty against any defect in materials and workmanship from the date of shipment. This warranty is not transferable and not applicable to the used or demonstration products. The obligation of us arising from a warranty claim shall be limited to repairing, or as an option, replacing without charge, any assembly or component (except batteries and chargers).
S30 Satellite Meter Manual 1.General Introduction S30 Satellite Meter is an ideal testing instrument for satellite dish installation which has extremely fast response and high accuracy and stable display. It can display MER to judge if the signal is exist.
S30 Satellite Meter Manual 2.Panel Introduction 2.1 Appearance Selection Power on/off Charging Port Return USB Port Charging Indicator Main Menu RF Input...
S30 Satellite Meter Manual 2.2 Keypad 、 :Increase and decrease. 、 :Left and right circularly selection. :Power on/off(hold it over 3 seconds to power off) or Confirmation. :Main Menu. :Retrun to previous menu or cancel :Charger Indicator.
S30 Satellite Meter Manual 2.3 Display Description 22KHz Status Lock Polarization Battery Satellite Transponder Signal Strength Signal Quality 22KHz: means 22KHz control function is available. Lock: means the signal value is above the threshold. Polarization:Switch between 13V(vertical/right) and 18V(horizontal/left).
S30 Satellite Meter Manual 3. Power Supply 3.1 Battery With a built-in 7.4V /1.6AH Lithium battery, the meter can continuously work for above hours. when the battery voltage drops below 6.0V, will automatically power off and then users must charge it with the attached charger for about 3 hours.
3.2 Charging Charge the meter before the first time use. Please charge the meter as follows: 1. Insert the charger output plug into S30 DC charge socket. 2. Connect the charger to AC 100V-240V Power and the charger indicator of meter is with red light.
Then press to select the current testing transponder. Align the dish, When S30 finds the signal, it will lock the signal and show (The signal is s2). Align the dish to maximize the signal value and quality(The beep frequency shows the signal quality ).
S30 Satellite Meter Manual 4.2 Spectrum Function 1.Press to main menu as figure 1, then press to select the spectrum icon. Figure 2 2. Press to set LO、POL、22KHz, refer to figure 3. Figure 3 、 : Move the marker or edit parameters.
Page 13
S30 Satellite Meter Manual 3. Press to figure 4 and align the dish and maximize the signal value and quality. : NOTE (1) Press to move markercursor. (2)Press to switch spectrum span ( 、 、 、 ) circularly 160M 320M...
Page 14
S30 Satellite Meter Manual 4. Press again to figure 5. The instrument will analyse signal and set parameters automatically and display the current signal strength and signal quality. Then align the dish slightly to maximize the signal quality. Figure 5 5.
S30 Satellite Meter Manual 4.3 Angle Calculate Press to main menu, press to select Angle icon as Figure 7, then enter into Figure 8. Input the current longitude and latitude, the meter will calculate the Azimuth(AZ)、Elevation(EL) 、Polarization(POL) , refer to figure 9...
S30 Satellite Meter Manual Figure 9 4.4 Setup Press to select “SETUP” in the main menu, refer to figure 10. Press to setup interface as figure Figure 10 Figure 11...
Page 17
S30 Satellite Meter Manual 4.4.1 System information The information of the instrument, Refer to Figure 12 It includes serial number, software version , hardware version and so on. Figure 12 4.4.2 General Press to select “Configure” in the figure 11...
Page 18
S30 Satellite Meter Manual 4.4.2.1 Backlight Set the backlight ON and OFF by pressing , refer to Figure 13. Figure 13 4.4.2.2 Shutdown Time Set shutdown time for inactive keypad after 5 minutes, 15 minutes, 30minutes by pressing Refer to figure 14...
Page 19
S30 Satellite Meter Manual 4.4.2.3 Beep Press to switch the “Beep” function ON or OFF. Refer to figure 15. Figure 15 4.4.2.4 Level Units Set level unit dBuV,dBmV or dBm by pressing buttons. Refer to figure 16. Figure 16 4.4.2.5 LCD CONTRAST In figure 16 press to select “CONTRAST”, refer to...
Page 20
S30 Satellite Meter Manual Figure 17 Figure 18 4.4.3 Satellite setting In figure 11 press to select “SAT SETTING”, refer to Figure 19. Figure 19...
Page 21
S30 Satellite Meter Manual Press to enter “SATELLITE LIST” interface, as figure 20. Press to select satellite name. Figure 20 Then press again to enter current setup interface, as figure 21. Figure 21...
Page 22
S30 Satellite Meter Manual 4.4.3.1 Satellite setup In Figure 21, press to enter figure 22. Then Press to select LO1、 LO2 and LONGITUDE, press enter into parameters edition and press to input parameters. Figure 22 4.4.3.2 Transponder setup In figure 22, press to return figure 21.
Page 23
S30 Satellite Meter Manual Press to enter figure 24 and figure 25. Then press toTYPE、 F、 SR、 POL、 22KHz、 ROLL, press to enter into parameters edition and press to input parameters. Figure 24 Figure 25...
S30 Satellite Meter Manual 4.4.4 Battery State The battery voltage is shown as a column graph as Figure 26. When the voltage is lower than 0%,the instrument will automatically power off. Figure 26 4.5 DISEqC Press to main menu, press...
Page 25
S30 Satellite Meter Manual Figure28 In figure28, press to return figure 27. Select “SEND” by press to diseqc-search, as figure 29. Figure 29...
S30 Satellite Meter Manual 5. Create User Channel Plan In order to enhance your work efficiency, please create user channel plan before test. S30 will detect all effective channels automatically and save in this channel plan. 5.1 Upload and Download Channel Plan The instrument can be connected with PC by USB cable to upload and download channel plan.
S30 Satellite Meter Manual 6. Specification Frequency Range: 950MHz-2150MHz Input Level Range: 30dBμV-110dBμV Unit: dBμV、dBmV、dBm Accuracy: ±3.0dB(20℃±5℃) Input impedance: 75Ω Symbol Rate(SR): 1Msps-45Msps Connector: Measurement: Average Power, MER and BER 22K Control: support Audio output: Built-in BUZZER Display: 128x64 LCD...
Page 28
S30 Satellite Meter Manual Working 0℃-40℃ Temperature: Storage -10℃-50℃ Temperature: Dimension(L*H*W): 153mm*93mm*42mm Weight: 338g...
Need help?
Do you have a question about the S30 and is the answer not in the manual?
Questions and answers
Is the Devisor s30 out of fate mine is 16 years old
No, the Deviser S30 Satellite Meter is discontinued and no longer available for purchase.
This answer is automatically generated