Important! Retain For Future Reference: Read Carefully; Warnings; Do's - Tesco 553-3071 Assembly Instructions Manual

Nursery furniture cotbed
Assembly instructions
www.tesco.com
Produced in Vietnam for TESCO Stores Ltd.
Tesco 2013
C
2
IMPORTANT! RETAIN FOR FUTURE
REFERENCE: READ CAREFULLY
When you are ready to start, make sure that you have plenty
of space and a clean, dry area for assembly.
Dont's
Number of people required to assemble
One person to assemble the product and two people to lift it
into position.
Time to assemble
Hi! Look out me throughout this manual. Wherever you see
my picture I will have a handy tip to help you with the assembly
of your product.
My first tip is: Before you start get a cup of tea, sit down and
read through these instructions carefully.
^^^^And for good measure my second tip is that you will need
the following tools to assemble this product, so gather them to
hand before you start.^^^^
Before you start
PZ3 6.5mm
Warnings
Failure to follow the warnings could result in serious injury.
Do's
To clean wipe with a sponge and warm soapy water.
Do not overtighten screws or bolts.
Due to the size of this product we recommend that it is
assembled in the room intended for use.
Unwrap all packaging materials and place the components
on top of the carton box or on a clean floor to prevent it from
scratching.
Check the pack and make sure you have all the parts listed.
Do not use power tools to construct this product.
Assembly to be carried out by a competent adult only.
During assembly children should be kept away from the
product due to possible risk of injury.
Ensure that this product is fully assembled as illustrated and
that all fittings are tightened properly before use.
This product has been designed for use by a "maximum of
one person at a time".
This product should only be used on firm, level ground.
Make sure the legs remain in contact with the ground.
During assembly keep small parts out of reach of children.
Check all screws or bolts are tightened and inspect regularly.
Do not use scourers, abrasives (including washing
powders), bleach or solvent based cleaners as they can
bleach or damage the product.
The cot bed is carefully designed for baby's safety and
features an adjustable height base so you can easily reach
baby in the early months.
The cot can be converted to a bed by separating the split end
panels and using the top sections as the headboard and
footboard.
The cotbed is suitable from approximately 0 months to 36
months.
Do not place this product near heat source, windows and
other furniture.
Do not use this product if any part is broken, torn or missing
and use only spare parts approved by Tesco Stores Ltd.
Be aware of the risk of open fire and other source of strong
heat, such as electric bar fires, gas fires, etc. in the near
vicinity of the cot.
Do not leave anything in the cot or place the cot close to
another product, which could provide a foothold or present a
danger of suffocation or strangulation, e.g. strings,
blind/ curtain cords, etc.
Do not use more than one mattress in the cot.
The thickness of the mattress shall be such that the internal
height (surface of the mattress to the upper edge of the
cot frame) is at least 500mm in the lowest position of the cot
base and at least 200mm in the highest position of the cot base.
The cot bed is suitable for a mattress of 1350 mm in length
and 635 mm in width, or no less than a size of
1400 mm x 680 mm.
All assembly fittings should always be tightened properly and
fittings should be checked regularly and retightened as
necessary.
To prevent injury from falls, when the child is able to climb out
of the cot, the cot shall no longer be used for that child. The
cot should be converted to a bed.
Children are likely to play, bounce, jump and climb on beds,
therefore the child's bed should not be placed too close to
other furniture or windows, blind cords, curtain pulls or other
strings or cords. It should be placed either tight to any wall or
have a gap of 300mm between the wall and the side of the bed.
The bed can be carefully dismantled for storage or
transportation.
Designed and manufactured to BS EN 716:2008 and
BS 8509:2008 + A1:2011
1 hour
Tradesman's tips