USER MANUAL – RAIZER – GB VERSION 1.4 1. Foreword Congratulations on purchasing your new Raizer. This is an original user manual for your new Raizer. NB: It is important to read this manual before using the Raizer. The Raizer is a battery-powered mobile lifting chair which raises a fallen person up to an almost standing position in a few minutes.
The max. load of the Raizer is 150kg with max. 1 person at a time on the chair. The max. load is also stated on the CE-mark on the rear of the seat. The Raizer can be used approx. 40 times at full load on a full charge. A charger is included with your Raizer.
With heavy loads on the Raizer, the chair may sink slowly if it is not in operation – this is completely normal. For safety reasons the Raizer is designed to sink slowly under heavy loads.
The seat is fitted with a seatbelt to secure the person using the chair. DO NOT use the chair until this person is secured with the seatbelt around their hips. After assembly of the Raizer under the person on the floor, fasten and click the seatbelt around the hips.
The Raizer will normally be supplied by your dealer. The chair is ready for use upon delivery. The Raizer can be transported in the 2 supplied bags. One is a case for the seat itself. The seat is carried by the turquoise handgrip.
The assistant can raise the fallen person to a sitting or almost standing position ready for relocation. To use the Raizer, hold down the button for the entire lift. The lifting will stop if the button is released.
Chair down STOP button The rotating legs must be fitted correctly before the Raizer can operate. The green LED will be lit when the device is ready for use. (see items 10.2 and 10.3 of section 10) Operate the Raizer with a continuous press of the “up arrow”...
Page 19
In this state there is a max. of 0-5 lifts left in the battery. You will/need to charge the Raizer (see section 12, Charging). Liftup A/S | Hagensvej 21| DK-9530 Støvring | Denmark | +45 96 86 30 20 | mail@liftup.dk | www.liftup.dk | CVR DK-1015 3964...
Press here to drive the chair downwards. It will only run for as long as the button is activated. *Supplementary equipment Liftup A/S | Hagensvej 21 | DK-9530 Støvring | Denmark | +45 96 86 30 20 | mail@liftup.dk | www.liftup.dk | CVR DK-1015 3964...
How to reset transmitter and receiver: To reset a remote control* so it is no longer associated with the Raizer, do as follows: Press the UP (↑ ) and DOWN (↓ ) buttons on the remote control* at the same time and hold them down for approx.
Run the Raizer into a horizontal position and disassemble. Put all parts into the carrying bags. Liftup A/S | Hagensvej 21 | DK-9530 Støvring | Denmark | +45 96 86 30 20 | mail@liftup.dk | www.liftup.dk | CVR DK-1015 3964...
The LED will be lit yellow to indicate charging. A green LED indicates a fully-charged battery. Liftup A/S | Hagensvej 21| DK-9530 Støvring | Denmark | +45 96 86 30 20 | mail@liftup.dk | www.liftup.dk | CVR DK-1015 3964...
DO NOT use running water, a high-pressure jet or a hose directly on the Raizer. 13.2 Mechanical maintenance The mechanical maintenance of the Raizer shall normally only be undertaken in connection with the regular annual service inspection. This is to be undertaken by a qualified service technician in accordance with the checklist in section 14.
The dealer you have bought the Raizer from will offer this service, but if you wish to use another service provider, you as the owner of the Raizer is responsible for ensuring that the chosen service technician is suitably qualified in the product in question.
Rear leg complete, left hand side / red 102967 Rear leg complete, right hand side /green Liftup A/S | Hagensvej 21 | DK-9530 Støvring | Denmark | +45 96 86 30 20 | mail@liftup.dk | www.liftup.dk | CVR DK-1015 3964...
Remote control* does not work The remote control* is not See section 10.7. correctly paired with the Raizer *Supplementary equipment Liftup A/S | Hagensvej 21 | DK-9530 Støvring | Denmark | +45 96 86 30 20 | mail@liftup.dk | www.liftup.dk | CVR DK-1015 3964...
Need help?
Do you have a question about the RAIZER and is the answer not in the manual?
Questions and answers