Port Settings - araknis AN-210-SW-R-8-POE Product Manual

Araknis Networks AN-210/310-SW-F/R Manual
Product Manual

Port Settings

Configure 802.1x settings for each switch port.
Figure 63. 802.1x Port Settings Menu
• Port – Switch port identifier.
• Mode – Options:
• Disabled – 802.1x is disabled through the port.
• Auto – Port allows only packets used for authentication and network discovery until the client is
authenticated, then allows uninterrupted traffic.
• ForceUnAuthorized – The port will remain unauthorized state and ignore all attempts to
authenticate a client.
• ForceAuthorized – The port always behaves as if an authenticated client is connected.
• Reauthentication – Enable or disable reauthentication by the switch. If enabled, a client that failed to
authenticate will not be allowed to try again until the next period based on the Period Setting.
Default: Enabled
• Reauthentication period – Set the reauthentication period.
Default: 3600 seconds
• Quiet Period – Set the quiet period.
Default: 60
Supplicant Period – Set the Supplicant period.
•
Default: 30
Max Retry – Set the Max Retry value.
•
Default: 2
Authorized Status – Displays the current authorization status of the port.
•
Guest VLAN – Enable or disable guest VLAN use for the port.
•
Default: Enabled
Default:
Table of Contents
66
© 2016 Araknis Networks
®