Changing A Wheel - Seat MII Owner's Manual

● Screw the inflator tube
the sealant bottle. The bottle's seal will break
automatically.
● Remove the lid from the filling tube
›››
Fig. 48 and screw the open end of the
3
tube into the tyre valve.
● With the tyre sealant bottle upside down,
fill the tyre with the contents of the sealant
bottle.
● Remove the bottle from the valve.
Place the insert back into the tyre valve us-
●
›››
ing the tool Fig. 48
1
Inflating the tyre
● Screw the compressor tyre inflator tube
›››
Fig. 48 into the tyre valve.
5
● Check that the air bleed screw is closed
›››
Fig. 48 .
7
● Start the engine and leave it running.
›››
● Insert the connector
vehicle's 12-volt socket
● Turn the air compressor on with the ON/OFF
›››
switch Fig. 48 .
8
Keep the air compressor running until it
●
reaches 2.0 to 2.5 bar
(29-36 psi/200-250 kPa). A maximum of 8
minutes.
Disconnect the air compressor.
●
● If it does not reach the pressure indicated,
unscrew the tyre inflator tube from the valve.
36
›››
Fig. 48 into ● Move the vehicle 10m so that the sealant is
3
distributed throughout the tyre.
● Screw the compressor tyre inflator into the
valve.
● Repeat the inflation process.
● If the indicated pressure still cannot be
reached, the tyre is too badly damaged. Stop
and request assistance from an authorised
technician.
● Disconnect the air compressor. Unscrew
the tyre inflator tube from the tyre valve.
.
● When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
Check the pressure again after 10 minutes
●
›››



Fig. 48 into the
9
›››

page 121.
The essentials
page 74.
›››
in TMS (Tyre Mobility System)* on
page 73
›››
page 72

Changing a wheel

Vehicle tool kit
Components of the vehicle tool kit
Fig. 49
Screwdriver with hexagon socket in the
1
handle
Adapter for anti-theft bolt.
2
Towline anchorage, removable.
3
Wire hook for removing the hub caps.
4
Jack.
5
Wheel spanner.
6
Wheel bolt cap clips.
7

›››
in What to do first on page 35

›››
page 70