Changing Margins - Toshiba E-STUDIO2000AC Printing Manual

2.PRINTING FROM WINDOWS APPLICATIONS
 Changing Margins
Sets the margins for pages. You can usually set margins in the application you are using. Use this option if you cannot
make settings from the application.
 When [Booklet] is selected from [2-Sided Printing], this option is unavailable.
 This cannot be used to specify the binding margin for Booklet printing.
Display the [Finishing] tab menu.
1
Select [Use Custom Margin], and then click [Details].
2
Set the margins as needed, and then click [OK].
3
Extend Printing Area: Select to extend the printing area.
This equipment does not support borderless printing. Some parts are not printed to the edges even if you specify
margins to 0 mm due to the restrictions on this equipment.
Margin: Enter a value between 4.2 to 100 mm.
Units: Select the unit of measurement from [mm] or [inch].
Restore Defaults: Restores the [Custom Margin] settings to their defaults.
Set other printing functions as needed, and then click [OK].
4
Click [Print] or [OK] to send the job.
5
The following printing areas are applied if you specify margins to 0 mm.*
 e-STUDIO5005AC Series: 4.2 mm from the top, 3.5 mm from the bottom, and 2.0 mm from left and right edges.
 e-STUDIO5008A Series: 4.0 mm from the top, 2.5 mm from the bottom, and 2.0 mm from left and right edges.
* Excluding paper sizes [305 x 457 mm], [320 x 450 mm], [320 x 460 mm], and [13 x 19"].
36 Setting the Layout and Finishing Options