Connecting To A Tv Only - Philips DVDR1000 Owner's Manual

10 Hookups (cont'd)
4
1
Connect your Antenna or Cable TV signal to the ANTEN-
NA jack on the rear of the DVD Recorder.
2
Connect the DVD Recorder's COMPONENT VIDEO OUT
Y P P jacks (EXT 3) to the corresponding COMPONENT
B R
VIDEO IN jacks on the TV. Use the supplied three-strand com-
ponent video cable, which has ends with red, blue, and green
stripes. Match the cable stripe colors to the jack colors.
3
Connect the DVD Recorder's red and white AUDIO OUT
(Left and Right) (EXT 3) jacks to the left/right AUDIO IN
jacks on the TV. Use one of the supplied two-strand audio cables,
which has ends with red and white stripes. Match the cable stripe
colors to the jack colors.
4
Connect the supplied power cord to the MAINS (AC
Power) jack on the rear of the DVD Recorder.
Connect the power cords of the DVD Recorder and the TV
to a power outlet.
5
Press the STAND BY/ON button on the front of the DVD
Recorder to turn on the DVD Recorder. The STAND BY/ON
light will turn green.
6
Turn on the TV power. Set the TV to the correct
Component Video In channel. See your TV owner's manual for
details. Or, change channels at the TV until you see the DVD screen
saver or Initial Setup screen on the TV screen. The Initial Setup
screen will appear the first time you turn on the Recorder. Go to page 16
to continue.

Connecting to a TV Only

TV has Component Video In Jacks
2
Antenna
or Cable TV
Signal
EXT 2 EXT 1
1
Back of TV
(example only)
Y RIGHT AUDIO IN
Pb/Cb
LEFT AUDIO IN
Pr/Cr
EXT 3 EXT 3
COMPONENT VIDEO PROG
SCAN
Y Y Y
L L
P P P L
B B B
R
P P P
R R R
R R
EXT 1/2
Y RIGHT AUDIO IN
Cb/B-Y LEFT AUDIO IN
Cr/R-Y
3
IN
RC 6
Helpful Hints
• If your TV has Progressive Scan,
connect the DVD Recorder's
PROG SCAN OUT Y P
B
to the TV's Progressive Scan In
jacks instead. Progressive Scan
produces a clearer picture by
doubling the number of visible
picture lines per field. This pro-
vides a jitter-free, sharp, quiet
picture. Only use these connec-
tions if your TV has Progressive
Scan. Check your TV manual
for more information.
• On the TV, the component
video in jacks may be labeled
YUV or Pr/Cr Pb/Cb Y and may
be green, blue, and red.
P jacks
R