Wireless Network Connection By Wps - Yamaha DISKLAVIER ENSPIRE ST/PRO Owner's Manual

Chapter
2
Getting Started

Wireless Network Connection by WPS

If your wireless router (access point) supports WPS, you can easily
connect the Disklavier to a network just by following the procedures below,
without making any additional settings, such as entering a password.
1
Press the POWER
2
Connect the USB wireless LAN adaptor (UD-WL01) to the
USB port on the rear of the switch box.
3
Check that the WLAN switch on the rear of the switch box
is set to "RT."
4
Press the POWER
5
Hold down the WPS button on the USB wireless LAN
adaptor (UD-WL01) for at least five seconds.
The LED lamp on the USB wireless LAN adaptor (UD-WL01)
flashes every 0.5 seconds.
15
button to turn the power off.
LED lamp
WPS button
WLAN switch
button to turn the power on.
Note:
To check whether your wireless
router (access point) supports WPS,
refer to the owner's manual supplied
with your wireless router (access
point).