Summary of Contents for Renewair EV130
- Page 1 INSTALLATION, OPERATION & MAINTENANCE MANUAL ENERGY RECOVERY VENTILATOR EV130 EV200 EV300 MODEL: EV130 MODEL: EV200 MODEL: EV300 RENEWAIRE.COM...
-
Page 2: Product Info
EV130, EV200, AND EV300 ABOUT RENEWAIRE For over 30 years, RenewAire has been a pioneer in enhancing indoor air quality (IAQ) in commercial and residential buildings of every size. This is achieved while maximizing sustainability through our fifth- generation, static-plate, enthalpic-core Energy Recovery Ventilators (ERVs) that optimize energy efficiency, lower capital costs via load reduction and decrease operational expenses by minimizing equipment needs, resulting in significant energy savings. - Page 3 F° in. wg Passive frost-free design under most DUCT CONNECTIONS Heating residential conditions. 0° 32° EV130 & EV200 - Insulating double collars with Cooling Total Recovery Efficiency % six-inch/eight-inch round connections for flexible 35° 95° WARRANTY or rigid duct work.
-
Page 4: Indoor Unit
Push-button point-of-use controls (PBL), PTL req'd. Total qty. 2, MERV 8, spun-polyester media: Percentage timer control with 10 1/2" x 10 1/2" x 1" furnace interlock (FM) Note: Electric Duct Heater is not available on the EV130. ELECTRICAL DATA UNIT PERFORMANCE CORE PERFORMANCE Volts... - Page 5 SPECIFICATIONS & DIMENSIONS STANDARD INDOOR UNIT SPECIFICATIONS Ventilation Type: Max. Shipping Dimensions & Weight (on pallet): Static plate, heat and humidity transfer 34" L x 44" W x 34" H 110 lbs. Typical Airflow Range: 100-200 CFM Motor(s): Standard Features: Qty.
- Page 6 STANDARD INDOOR UNIT SPECIFICATIONS Ventilation Type: Max. Shipping Dimensions & Weight (on pallet): Static plate, heat and humidity transfer 34" L x 44" W x 34" H 115 lbs. Typical Airflow Range: 150-300 CFM Motor(s): Standard Features: Qty. 1, Double-shaft standard motor Painted cabinet Accessories: Line-cord power supply...
-
Page 7: Installation
EV130, EV200, AND EV300 INSTALLATION BEFORE YOU BEGIN PLANNING YOUR INSTALLATION Read all instructions before installing the unit. Also review supplemental instructions included with any controls that will be installed. Carefully unpack and inspect the unit for shipping damage. Open the access door and inspect inside the unit. - Page 8 The Exhaust Air Duct and the Outside Air Duct connect the unit to the outside. Flexible insulated duct is typically used. See Duct Sizes. DUCT SIZES EV130 - 6" round insulated duct, 8" round insulated duct may be used to maintain maximum airflow Exhaust Air & Outside Air (EA & OA) EV200 and EV300 - 8"...
- Page 9 INSTALLATION APPLICATIONS PLANNING YOUR INSTALLATION See figures F2-F5 for examples of some common installation approaches (EV130 shown). Separate Room Air Pick-up - Separate Air and Fresh Air Supply Fresh Air to Furnace Return Air Trunkline Note: ERV blower may be operated separate from furnace blower.
- Page 10 EV130, EV200, AND EV300 INSTALLATION PLANNING WARNING YOUR INSTALLATION RISK OF FIRE, ELECTRIC SHOCK, OR INJURY. OBSERVE ALL CODES AND THE FOLLOWING: 1. Before servicing or cleaning the unit, unplug 9. Sufficient air is needed for proper combustion the unit line cord. Make sure unit is not running and exhausting of gases through the flue before opening its door.
- Page 11 EV130, EV200, AND EV300 INSTALLATION MOUNTING THE UNIT INSTALLATION INSTRUCTION Unit may be installed in any orientation Mounting the ERV to a stud wall Orient the unit for the simplest duct layout and connections. Note however that the door Foam Tape Metal Washer is equipped with slide-off hinges.
- Page 12 EV130, EV200, AND EV300 INSTALLATION INSTALLING OUTSIDE AIR AND EXHAUST AIR DUCTS INSTALLATION INSTRUCTION Ducts connecting the unit to the outside must be well-insulated. Band or tape inner duct liner to inner flange of appropriate collar. Drive a sheet metal screw through liner to CAUTION secure duct spiral wire to collar.
-
Page 13: Start-Up & Operation
INSTALLING CONTROLS Optional controls: RenewAire offers a variety of controls specifically designed to work with the EV130/200/300 products. These include: PTL (a two wire percentage timer), FM (a six wire percentage timer that will interconnect with the furnace blower), and PBL (point of use push button control). Other controls that throw an unpowered switch may also be used. -
Page 14: Maintenance
EV130, EV200, AND EV300 MAINTENANCE SERVICE PARTS EV130, EV200, AND EV300 www.renewaire.com (800) 627- 4499 support@renewaire.com RENEWAIRE.COM 1.800.627.4499 INSTALLATION, OPERATION AND MAINTENANCE MANUAL... - Page 15 EV130, EV200, AND EV300 MAINTENANCE Keep your ERV performing at its best by cleaning it as described below: REQUIREMENTS TO CLEAN THE ENERGY EXCHANGE ELEMENT WARNING 1. Remove the filters (see below). RISK OF ELECTRIC SHOCK 2. Vacuum the exposed faces of the energy exchange core with a soft brush attachment.
- Page 16 UNMATCHED VENTILATION SUPPORT As much as our unsurpassed quality and performance, our customers can also depend on our professional support staff for swift, professional assistance with all their technical, application, and service needs. Every time. Anywhere. At RenewAire — unlike other ventilation suppliers — advanced ventilation solutions are all we do.
Need help?
Do you have a question about the EV130 and is the answer not in the manual?
Questions and answers