Servicing Fixtures And Tools; Re-Write For Dvd Firmware - Sanyo DP26671 Service Manual

26" hdtv lcd / dvd combo

Hide thumbs Also See for DP26671:

Owner's manual (41 pages)

Service manual (76 pages)

Table Of Contents

Table of Contents

JG176 Up-Date Disc

1. Turn on the power, and set the DVD mode.

2. Confirm that the "No Disc" will be appeared on the screen.

3. Insert Up-date disc.

4. When disc is read normally, Update is started and "Upgrade file DETECTED"

"File Copying" is displayed.

After 5 seconds, displayed words is changed to "Do not power off", "UPGRADING" (Black Screen) (Refer to Fig. 1) ,

then update disc is ejected.

NOTE: After this, please never turn off AC. If you turn off AC, update fails. When update fails,

update by CD-R can not be carried out after it. Therefore please be careful enough

Upgrade File DETECED

DO not power off

UPGRADING

5. After the Up-Date, Logo screen will appear.

6. After update was finished, "Power OFF/ON reset" is carried out automatically

Then, Screen is changed to Logo screen.

7. Unplug the AC cord, then plug it in.

After the write, set to the initializing of shipping.

8. Turn on the power, and set the DVD mode.

9. Press both VOL. DOWN button on the set and Channel button (4) on the remote control for more than 2 seconds.

The "Factory Initial Complete" will appear on the screen.

11. Then unplug the AC cord, and plug it in.

CHECK FOR THE FIRMWARE VERSION

12. Turn on the power, and set the DVD mode.

13. Press both Channel button (1) on the remote control and the STOP button on the set for more than 2 seconds.

Firmware version will be displayed on the top left of the screen.

F/W Ver. AFJKA1210A

Laser drive time

DVD LD : 0Hour

CD LD : 0Hour

When the changed version displays, the Re-write will be completed.

14. Turn off the power