Flex State Parameters - GE F35 Instruction Manual

CHAPTER 5: SETTINGS
Figure 5-49: User-programmable pushbutton logic (Sheet 2 of 2)
User-programmable pushbuttons require a type HP or HQ faceplate. If an HP or HQ type faceplate was ordered
separately, the relay order code must be changed to indicate the correct faceplate option. This can be done in the
EnerVista software with the Maintenance > Enable Pushbutton command.

5.3.15 Flex state parameters

SETTINGS  PRODUCT SETUP  FLEX STATE PARAMETERS
 FLEX STATE
 PARAMETERS
This feature provides a mechanism where any of 256 selected FlexLogic operand states can be used for efficient
monitoring. The feature allows user-customized access to the FlexLogic operand states in the relay. The state bits are
packed so that 16 states are readable in a single Modbus register. The state bits can be configured so that all states of
interest are available in a minimum number of Modbus registers.
F35 MULTIPLE FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
PARAMETER 1:

Off

PARAMETER 256:

Off
Range: FlexLogic operand
Range: FlexLogic operand
PRODUCT SETUP
5
5-115