Page 1
OWNER’S GUIDE PERFECTLY SIMPLE WARMTH FOR ANY ROOM IDEAL WARMTH FOR LARGER AREAS For how-to videos or more information, please visit: http://cadetheat.com/install/com-pak cadetheat.com/espanol/com-pak ESPAÑOL ver la guía del propietario en cadetheat.com 855.CADET.US Vancouver, Washington tested to UL standards...
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 6. To disconnect heater, turn con- 1. Read all instructions before using trol(s) to off, and turn off power to this heater.
Connecting a 240 volt heater to a 120 volt electrical supply will only give you one quarter of the heat output. Unanswered questions? Call our technical support team in Vancouver, Washington at 855.CADET.US. PARTS OF YOUR HEATER high-temperature...
Verify power has been turned off before starting any work! • The Com-Pak model CS can be mounted with the element up, or with the element on the left. For ceiling installation, see page 5. For multiple heater wiring, see page 6.
Page 5
INSTALLATION INSTRUCTIONS INSERT THE HEATER ASSEMBLY IN THE WALL CAN STEP 4 Wire connections Your heater has two connection wires on the back. Your supply wire has two connection wires and a supply ground wire. 1. Connect supply ground wire to grounding screw in wall can (See Figure 4).
THE SAME WARRANTIES AS THE PRODUCT. LIMITED TWO YEAR WARRANTY: Cadet will THE INSTALLATION OF REPLACEMENT PARTS repair or replace any Cadet Com-Pak (CS) or DOES NOT MODIFY OR EXTEND THE UN- Com-Pak Twin (CST) heater found to be defective DERLYING WARRANTIES.
OPERATING INSTRUCTIONS 1. The heater must be properly 3. Do not tamper with the high- installed before it is used. temperature safety shutoff. 2. Do not operate without grill. How to operate your heater The room temperature is controlled by a thermostat located either on the wall, or on the heater. Once installation is complete and power is on, follow the steps below for your thermostat.
1. Thermostat is defective. 1. Replace thermostat. turn off. 2. No thermostat hooked up 2. A thermostat is required for all Com-Pak heaters. Purchase to control heater. a built-in or wall thermostat for your heater. 3. Incorrect heater wattage 3. Install higher wattage model or additional heaters if circuit for room size.
Need help?
Do you have a question about the COM-PAK and is the answer not in the manual?
Questions and answers