Bowflex TREADCLIMBER TC200 Assembly & Owners Manual page 59
Hide thumbs
Also See for TREADCLIMBER TC200:
- User manual ,
- Troubleshooting manual (8 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Condition/Problem
Belts stop turning while in use
Console displays "INSERT
SAFETY KEY"
Console displays "NOTE
LUBRICATE BELT" followed by
"REVIEW USER MANUAL"
Console displays "ERROR
COMMUNICATION" followed by
"RESTART MACHINE"
Console displays "ERROR
MOTOR BOARD" followed by
"CONTACT SUPPORT"
Console displays "ERROR
OVERLOAD" followed by "COOL
DOWN 20 MIN"
Console displays "ERROR MO-
TOR WIRE" followed by "CON-
TACT SUPPORT"
Console displays "ERROR
STUCK BUTTON" followed by
"Name of BUTTON"
Console displays "PLEASE
CYCLE POWER" and one of the
following: "MCB COMM LOST",
"MCB RELY STUCK CLSD",
"MCB RELY STUCK OPEN",
"MCB TACH OVER SPEED",
"MCB TACH TIMEOUT", "MCB
COMM TIMEOUT", "MCB OVER
CURREN SOC", "MCB OVER
CURRE CRIT", "MCB OVER
CURRE DMAG", and "MCB HW
OVERS SPEED"
Things to Check
Safety key
Motor overload
Outlet
Safety Key
Belt lubrication
I/O Cables
Motor Control Board
Motor Covers
Motor Connections
Specified button
Motor Control Board
Assembly / Owner's Manual
Plug Safety Key into Console (See Emergency Stop Procedure in Safety Warn-
ing Labels section).
Unit may be overloaded and drawing too much current, causing unit to shut
power down to protect motor. Consult belt lubrication schedule to determine
if belts need lubrication, check walking belt tension, and restart unit.
Outlet may not have enough power available for the machine due to other
devices on same circuit. Remove any devices from power circuit and restart
machine.
Insert Safety Key into Safety Key Port on Console.
Consult lubrication schedule and apply if necessary. Push ENTER button to
exit the notice.
Restart machine. If error persists, contact Customer Service for further as-
sistance.
Contact Customer Service for further assistance.
Cycle power off and allow the machine to cool down for at least 20 minutes.
Be sure the Motor Cover vents are free of debris. If issue recurs contact
Customer Service for further assistance.
Contact Customer Service for further assistance.
Release specified button. If error persists, make note of the stuck button and
contact Customer Service for further assistance.
Restart machine. If error persists, contact Customer Service for further as-
sistance.
59
Solution
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TREADCLIMBER TC200 and is the answer not in the manual?
Questions and answers
both treads have moved to the outside rail at the bottom. How do I adjust that?
To adjust the walking belts on a Bowflex TreadClimber TC200 that have moved to the outside rail at the bottom, follow these steps:
1. Observe Belt Alignment – While the machine is operating, check where the belts are positioned on each Treadle.
2. Locate Adjustment Bolts – The Walking Belt Adjustment Bolts are at the front end of each Roller.
3. Make Adjustments –
- If the belt is tracking too far to the right, use a properly sized Hex Key to turn the right adjustment bolt clockwise in full turn increments.
- If the belt is tracking too far to the left, turn the left adjustment bolt clockwise in full turn increments.
Continue adjusting in small increments until the belts are centered properly.
This answer is automatically generated