Elkay EZH20 Installation, Care & Use Manual

Buy at
Installation/Care/Use Manual
EZH20 Surface Mount Bottle Filling Station
Installer
To assure you install this model easily and correctly, PLEASE READ THESE
SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK
YOUR INSTALLATION FOR COMPLIANCE WITH ALL PLUMBING, ELECTRICAL
AND OTHER APPLICABLE CODES. FOLLOW ALL WARNINGS AND CAUTIONS
CAREFULLY. After installation, leave these instructions with the customer for future
reference.

Warnings

1. Use with clean, clear, fresh potable drinking water only! Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before the system.
2. Connect Power Cord only to a grounded three prong electrical outlet with electrical power that:
a. MUST be rated for this product as specified on product data label.
b. MUST have over-current protection (e.g. Fuse, Breaker).
c. MUST have Ground Fault Circuit Interrupt protection (GFCI).
d. These products are designed to operate on 20 to 105 psi supply line pressure. If inlet pressure
is above 105 psi, a pressure regulator must be installed in supply line. Any damage caused by
reason of connecting this product to supply line pressure lower than 20 psi or higher than
105 psi is not covered by warranty
EZWSSM-1A, EZWSSMJO-2A, LZWSSM-1A, LZWSSMJO-2A
| 855-558-9600 | BottleFillingStations.com
Model
LZWSSM
.
Page 1
IMPORTANT
THIS IS AN INDOOR APPLICATION ONLY!
ALL SERVICE TO BE PERFORMED BY AN
AUTHORIZED SERVICE PERSONNEL.

TOOLS/ITEMS REQUIRED

BUT NOT SUPPLIED
- SERVICE STOP VALVE WITH 3/8"
COMPRESSION OUTLET
- FASTENERS FOR WALL TYPE (8 REQ'D.)
- SLIP JOINT DRAIN UNION OR
COMPRESSION CLAMP
- 5/32" HEX-WRENCH
98764C (Rev. H - 06/16)