Wheel cover (optional accessory)
To install the wheel cover:
1.
Put together the hinges of the wheel cover and
the tool.
1
014198
2.
Insert the axes.
014197
3.
Fasten the axes by the stop rings.
4.
Lock the wheel cover.
NOTICE:
When opening the wheel cover, press and open both
the stoppers simultaneously. Opening only one stopper
may cause crack on the wheel cover.
OPERATION
CAUTION:
Always hold front and rear handle. Never hold
•
the tool body or guards. Hands may slip from
these locations and contact blade. Contact with
the blade may result in personal injury.
Make sure to hold the tool firmly when turning on
•
or off the tool or when cutting. Otherwise the tool
may fall and cause personal injury.
007316
For stable cut, always keep at least two teeth in the cut.
1. Axis
1
1. Stop ring
1
004747
Select the proper cutting position for your workpiece by
referring to the figure.
014195
Hold the tool with both hands as shown in the figure.
Before turning on the tool, always make sure that the
stopper plate contacts the workpiece and the blade is
clear of the workpiece.
Turn the tool on and wait until the blade attains full
speed. Gently lower the blade into the cut. The weight
of the tool or slightly pressing the tool will supply
adequate pressure for the cutting. Do not force the tool.
As you reach the end of a cut, release pressure and lift
it slightly so that it will not fall against the workpiece.
NOTICE:
Applying excessive pressure to the tool or twisting
•
of the blade may cause bevel cutting or damage to
the blade.
When not using the tool for a long period of time,
•
remove the blade from the tool.
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
Cutting lubricant
CAUTION:
Never use cutting oil or apply excessive amount of
•
wax to the blade. It may cause the blade to slip or
come off unexpectedly.
When cutting cast iron, do not use any cutting wax.
•
8