Europe - Edis6; Europe - Edis8; Europe - 36-1 Trigger Disc - MegaSquirt MS3 Hardware Manual

MS3base/V3.0 Hardware Guide

12.3 Europe - EDIS6

up to 1995ish Mondeo V6 automatic
Ford/Cosworth Granada Scorpio 24v V6
Module located rear left of engine bay as you face the car.
Known part numbers are: 90GB-12K072-AB

12.4 Europe - EDIS8

Chances of finding one of these in a scrapyard are very low! Not known to have been installed on any European
built vehicles. Your best bet is either to import a module from the USA or buy new. I would suggest buying the
other bits locally.
For connectors try one off another car if all the wires are in use or one off an ESC module. The number of wires
used in the connector varies so check they are all there!
There is a possibility of using 2 EDIS4 modules to drive a V8. But now that the MS ECU can directly drive 4 coils
(V8 in wasted spark) this is no longer necessary.

12.5 Europe - 36-1 trigger disc

The 1.8CVH Sierra has a useful disc pressed onto the back of the crank pulley
All of the other CVH installs have the trigger teeth cut into the flywheel and so are useless.
For a scrap yard trigger disc, remove from 1.8CVH Sierra. You will need to stop engine from turning, various
methods have been suggested.
1) remove the head, put some old bolts or other junk into the bore and refit the head.
2) remove a spark plug and put a long bar down the hole
3) remove a plug from cylinder with piston at BTDC and coil in some rope, remove rope when finished
4) Jam something into the flywheel teeth
If you are after a pressed steel disc, try part no. 1078767 from Ford, this came on the 16v DOHC Granada
engines. Alternatively many retailers sell universal 36-1 trigger wheels.
(c) 2014-6 James Murray 2016-11-13
Page 201/222