Table of Contents
Advertisement
Available languages
Available languages
OPERATING INSTRUCTIONS
This fan is equipped with manual "MAN" and auto-
matic "AUTO" settings. Set the rocker switch to "MAN"
for manual mode, allowing the fan to continuously run
until the rocker switch is returned to the OFF "O" posi-
tion. Set the rocker switch to "AUTO" for the auto-
matic mode, which will turn the fan on and off based
on ambient room temperature. It may take 5 to 10
minutes for the fan to come on when the unit is cold.
T - Temperature Switch
M - Motor
K - Power Switch
NOTE: If any of the original wire as supplied with the appliance must be replaced, it
must be replaced with a wire of at least an equal temperature rating.
CAUTION: Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation. Verify proper operation
after servicing.
Electrical Wiring Diagram
AUTO
4
Fan Rocker
Switch
- Quick Links:
- Important Instructions
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WHF100 and is the answer not in the manual?
Questions and answers
what is the temperature if you have it on auto
The temperature setting for the Dyna-Glo WHF100 when it is on auto is 114°F.
This answer is automatically generated
dose the **** have a thermostat in it to start and shut off and if so what is the temperature on the thermostat if on auto
Yes, the Dyna-Glo WHF100 has a thermostat for automatic start and shut-off. In auto mode, the thermostat is set to operate when the heater gets above 113 degrees Fahrenheit.
This answer is automatically generated