Programming; Programming From The Part Program - Siemens SINUMERIK 828D Function Manual

S1: Spindles

16.7 Programming

16.7 Programming
16.7.1

Programming from the part program

Programming statements
Statement
SETMS:
SETMS(<n>):
M3:
M<n>=3:
M4:
M<n>=4:
M5:
M<n>=5:
S...:
S<n>=...:
SVC=...:
SVC[<n>]=...:
SPOS=...:
SPOS[<n>]=...:
1330
Description
Master spindle is the spindle specified in the following machine data:
MD20090 $MC_SPIND_DEF_MASTER_SPIND (initial setting of the master spindle in
the channel)
The spindle with the number <n> is the master spindle
(may differ from the initial setting:
MD20090 $MC_SPIND_DEF_MASTER_SPIND).
The master spindle must be defined for the following functions:
•
G95:
•
G96 S.../G961
S...:
•
G97/G971:
•
G63:
•
G33/G34/G35:
•
G331/G332:
•
G4 S...:
• Programming M3, M4, M5, S, SVC, SPOS, M19, SPOSA, M40, M41 to M45, and WAITS
without entering the spindle number
The current master spindle setting can be retained via RESET/part program end and
part program start. The setting is done via the machine data:
• MD20110 $MC_RESET_MODE_MASK
• MD20112 $MC_START_MODE_MASK
Clockwise spindle rotation for the master spindle
Clockwise spindle rotation for spindle number <n>
Counterclockwise spindle rotation for the master spindle
Counterclockwise spindle rotation for spindle number <n>
Spindle stop without orientation for the master spindle
Spindle stop without orientation for spindle number <n>
Spindle speed in rpm for the master spindle
Spindle speed in rpm for spindle number <n>
Cutting rate in m/min or feet/min for the master spindle
Cutting rate in m/min or feet/min for the spindle <n>
Spindle positioning for the master spindle
Spindle positioning for spindle number <n>
The block change is only performed when the spindle is in position.
Rev. feedrate
Constant cutting rate in m/min or feet/min
CancelG96/G961 and freeze last spindle speed
Tapping with compensating chuck
Thread cutting
Rigid tapping
Dwell time in spindle revolutions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions