Tektronix TDS3000 Series Program Manual page 348

Command Descriptions
WAVEAlert:BEEP
(TDS3000B Series and TDS3000C Series)
Group
Syntax
Arguments
Returns
Examples
WAVEAlert:HARDCopy
(TDS3000B Series and TDS300C Series)
Group
Syntax
2- 310
The beep sounds when a new waveform data varies significantly from the
accumulated (DPO) display of previous waveforms.
Acquisition
WAVEAlert:BEEP { OFF | ON | <NR1> }
WAVEAlert:BEEP?
OFF or <NR1> = 0 turns off the beep when a new waveform is significantly
different.
ON or <NR1> ¸ 0 turns on the beep.
Either 0 or 1 corresponding to beep OFF or ON.
WAVEALERT:BEEP ON
specifies that the beep is to sound when a new waveform data varies significantly
from previous waveforms.
WAVEALERT:BEEP?
returns either 0 or 1, indicating whether the beep is to sound when a new
waveform varies significantly from previous waveforms.
Executes a hardcopy operation on the waveform when a new waveform data
varies significantly from the accumulated (DPO) display of previous waveforms.
The hardcopy operation uses the port, and prints in the format and layout,
specified using the HARDCopy commands.
Acquisition
WAVEAlert:HARDCopy { OFF | ON | <NR1> }
WAVEAlert:HARDCopy?
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual