Join A Network Using Wps - NETGEAR A6210 User Manual

• Standalone driver and Windows WLAN Autoconfig. Install the adapter's standalone
driver and use Windows WLAN Autoconfig to join a WiFi network (see
Using a Standalone Driver and Windows WLAN Autoconfig
This is an alternate method that does not use WPS or NETGEAR genie. You can also
use this method if your computer does not include a CD drive.
You can also join hidden networks. For more information, see
page 18.

Join a Network Using WPS

Wi-Fi Protected Setup (WPS) is a standard for easily adding computers and other devices to
a home network while maintaining security. Before you use the WPS method to let the
adapter join a network, make sure of the following:
• Your WiFi router or access point supports WPS.
• The security on your WiFi router or access point is not set to WEP. WEP and WPS are
incompatible. You cannot use WPS if the security on your WiFi router or access point is
set to WEP.
Note: For information about using WPS to let the adapter a hidden network,
see Use WPS to Let the Adapter Join a Hidden Network

To use WPS to let the adapter join a WiFi network:
1. Insert the adapter into a USB port on your computer.
2. Press and hold the WPS button on the adapter for more than two seconds.
The WPS LED blinks. (The WPS button also functions as the WPS LED.)
3. Within two minutes, press the WPS button on your WiFi router or access point.
The adapter joins the network, which can take a few minutes. Your settings are saved in
a profile.
A6210 WiFi USB Adapter
Get Started and Connect to a WiFi Network
12
on page 15).
Join a Hidden Network
on page 18.
WPS button and LED
Join a Network
on