Presentation Idle Mode
When Presentation Idle Mode is selected, when there is no activity, the scanner
illumination turns off for a length of time. After scanning the Presentation Idle
Mode bar code, set the idle time duration (from 0-300,000 milliseconds) by scan-
ning digits from the
Save. Default = 500 (0.5 seconds).
When Off is selected, the scanner remains powered on.
Note: This selection is unavailable when the
Presentation LED Behavior after Decode
Note: This feature is not supported by the Orbit 7120plus scanner.
If you wish to turn off the LEDs immediately after a bar code is decoded, scan the
LEDs Off bar code, below. Default = LEDs Off.
Presentation Sensitivity
Note: This feature is not supported by the Orbit 7120plus scanner.
38
Programming Chart,
Presentation Idle Mode
LEDs On
beginning on page 225, then scanning
Illumination Lights
Orbit 7120plus/7190g User Guide
are set to off.
Off
* LEDs Off