Ucnet; Ip Address Settings; Permissions; Daw Button - PRESONUS studiolive III series Owner's Manual

8 Master Control
8.3

UCNET

UCNET
8.3

IP Address Settings

8.3.1
8.3.2

Permissions

DAW Button

8.4
UCNET is a special networking protocol that PreSonus created to enable advanced
remote control and audio transmission features between various PreSonus hardware
and software products. This includes devices running Studio One, Capture, UC
Surface, and QMix-UC software.
Note: For more information on networking configuration and setup for UCNET-
compatible products, please see the StudioLive Software Library Reference Manual.
In the Control Network area of the UCNET screen, you'll see the current IP address
of your StudioLive. This IP address can be assigned in one of three ways. Select the
necessary IP assignment mode by touching one of the following buttons:
• Dynamic. The IP address is assigned automatically upon connection to the
network, and can shift to a new address when necessary due to changes in
network availability. In this mode, a Renew button is shown onscreen. Touch this
button to renew the DHCP lease for your StudioLive.
• Static Self (Self-Assigned). The IP address is assigned automatically, but stays
the same thereafter until you need to change it. In this mode, an Apply button is
shown. Touch this button to auto-assign a new static IP address to your StudioLive.
• Static Manual. The IP address can be set manually, and remains the same until it
is changed. In this mode, an Edit button is shown. Touch this button to open the
Static Manual Edit screen, where you can specify IP address, subnet mask, and
gateway settings for your StudioLive as needed for your network configuration.
Touch each field in the form to bring up an onscreen keyboard for entry. When
you're finished entering the settings, press Apply to establish the new settings. To
exit without re-setting IP settings, touch the Cancel button.
As previously mentioned, some of the mixing functions of your StudioLive can be
controlled remotely by networked devices running UC Surface software. For some
applications, you may want to limit the degree to which a device can manipulate
your StudioLive. To make these choices, touch the Permissions button. You can also
reach these settings by pressing the Home button and navigating to the Settings
screen. For more information on setting mixer permissions, see Section 8.1.1.1.
Your StudioLive can act as a control surface for the mixer functions of a computer
running our Studio One DAW software. Press the DAW button to switch between
normal mixing functions and DAW control. To return to normal operation, press the
DAW button again.
While operating in DAW control mode, if there are more channels available in the
connected DAW or mixer than there are channel strips on your StudioLive, you can
press the Prev and Next buttons in the Bank section to switch between banks of
channels.
Note: At the time of the publication of this manual, DAW control has not yet been
implemented. This feature will be added in a future firmware update.
StudioLive™ Series III
Owner's Manual
74